Use this CineMilled Mini Adjustable Arm for Camerasfrom CineMilled Mini Adjustable Arm for Camerasto attach Aputure MC lights to your magnetic nail-on mount plate, thanks to its 1/4"-20 and 3/8"-16 screws. The arm has two ball heads that allow you to rotate your mounted accessories in any direction and secure their placement by tightening the integrated knob. Other lightweight devices like small monitors can also be mounted onto the arm.

1/4"-20 and 3/8"-16 Screw    Tighten via Knob    Dual Ball Heads    Mount Aputure MC Lights on Nail-On Mount

Related Questions and Answers

Q: 1. Ok...thanks for answer about 1 1/8" offset arm..!!...Would this Kupo Baby 5/8" Offset Arm, fit more snugly on C-stand with the same sized 5/8" stud, and not need a adapter...??

A: This Kupo Baby 5/8" Offset Arm will fit snugly on a C-stand.

Q: 2. So I want to fly my Sony fs700 on a Dji Ronin. Would this allow me enough wiggle room to operate efficiently or would I need additional parts?

A: You will be good with these two parts. If you were to add equipment to the back of the camera, say a battery, you would also need the CineMilled Pan Arm Extension for DJI Ronin Gen. 2 (Short) B&H # CICM502 or possibly the Long version. CineMilled Pan Arm Extension for DJI Ronin Gen. 2 (Long) B&H # CICM503 But if you are using just the FS700 and nothing on the back, the two extensions will be just fine.

Q: 3. Will this work with the Glide Gear DNA 6000 arm and vest?

A: This combination is unknown but it should work with any 7/8 post. The Glide Gear DNA 6000 is reported to be 7/8 so you should be good.

Q: 4. The CineMilled steadicam arm post adapter: Will this adapter work with Movi Pro - for Steadycam arm post?

A: Yes, this will work with the Movi Pro. The Movi Pro has a 30mm bar, which is the proper size for this adapter.

Q: 5. What size is the screw at the end of the arm?

A: This mic arm kit comes with a 3/8 thread on the head and an 5/8 adapter included for standard US mics clips and shockmonts.

Q: 6. Hi I have a Tiffen master series arm and Djı ronin 2 Which size should I take?

A: From what I can gather, this unit will not fit a master series arm.

Q: 7. Will the Ronin still fit in the standard case once these are installed?

A: yes it will

Q: 8. Will this work with the C100 mark 2 if you have the extension arms or is the viewfinder still an issue?

A: You cant mount it without them and balance the setup correctly. I have successfully used them with the C100. Yes the eyepiece hits the frame when you tilt back more than I dont know,30deg. But all you do is tilt the Ronin backwards and you are fine. To balance the tilt axis instead of the handle being straight up during the procedure, take it off the stand and rotate the handle backwards 90deg and then proceed to balance.

Q: 9. Hi i have an SK steadicam vest and i want to use it with the cinemilled armpost adapter and i want to know wich hole size i have to choose..!?

A: Unfortunately, neither we or CineMilled have heard of the SK Steadicam vest . We therefore ask you contact the manufacturer and then CineMilled with that information so that the proper adapter can be selected.

Q: 10. Does this work with the Ronin-MX as well?

A: Yes, this will work with the Ronin-M and Ronin-MX.