Power up to three devices from your RS3-compatible camera or component with this RS3 Cable to 0B LEMO Splitter from DigitalFoto Solution Limited. The 11.8" cable goes from an RS3 connector to a three-port 0B LEMO hub with two 0B LEMO 2-pin female ports and one 0B LEMO 3-pin female, each capable of outputting 14.8V.

Splits Single RS3 to Three LEMO Ports    Each Port Outputs 14.8V

Related Questions and Answers

Q: 1. Does it work with RS3?

A: No, the YC Onion YC RS2 Interlink Module for RS2 & RS3 Pro is not compatible with the DJI RS 3 gimbal, as the RS 3 does not have the electronic contacts for remote control like the RS 3 Pro does.

Q: 2. Will this work on the SmallRig 3252 in powering the DJI RS3 Pro?

A: The DigitalFoto Solution Limited Coiled D-Tap to Right-Angle LEMO 0B-Type Male 2-Pin Power Cable for Vaxis Wireless Transmitter and Tilta Power Base (1.6 to 4.9') will not power the DJI RS3 PRO. The DJI RS3 PRO is powered by the handle attached to the device and is charged by USB-C.

Q: 3. Will this carry 4K60p ? There is a pricey die-cast version from Atomos that is certified for 4K60P, but will this affordable one also do the job? After all HDMI2.0 is HDMI 2.0, no?

A: This does NOT work for me in 4K 60fps on a Ninja V and Sony FX3.

Q: 4. Can I use this cable to connect Atomos Ninja V with FX3 and display 4K 60fps or full hd 240fps video?

A: No, We would recommend the following higher quality Atomos HDMI cable for 4k and high framerate support Cable https://bhpho.to/37zzjPw

Q: 5. What is the polarity of the LEMO connector? Pin 1 hot?

A: Pin one of the Kondor Blue D-Tap to LEMO 0B-Type 2-Pin Male Power Cable (Raven Black) is ground and pin 2 is hot.

Q: 6. Does this cable support 4k 30fps vlog without dropping frames?

A: Hello David R, this cable will be able to do 4k30 but it will not be able to do 4k60. our HDMI 2.0 cable will be able to do the 4k60 frame rates.

Q: 7. Is this USB 3.1 gen 2?

A: The DigitalFoto Solution Limited USB Type-C Cable is rated at USB 2.0 speed and wattage by the manufacturer.

Q: 8. Will this work for the Tilta Nucleus-M motor?

A: We can only recommend the Tilta Nucleus-M D-Tap to 7-Pin Motor Power Cable as the correct power cable for the Tilta Nucleus-M motor. Tilta Nucleus-M D-Tap to 7-Pin Motor Power Cable BH #TIWLCTPTAP7P

Q: 9. Does this work with any Atomos product? Does it even work with any product that uses HDMI to HDMI?

A: We purchased this short HDMI coiled cable for our Ninja Blade by Atomos and it works well. We have had no problems with the link between the Blade and our C-100.

Q: 10. Is the 4pin lemo connection male or female?

A: The DigitalFoto Solution Limited 4-Pin LEMO to BNC Timecode Synchronization Cable for RED EPIC (1.6') LEMO is male.