This Milos Swivel Truss Coupler for 2" Tubes - Connect Easilyis designed for joining truss systems or pipes with an approximate 2" outer diameter. The set allows the clamps to rotate 360° and has two bolts that tighten down via wing nuts.

For Joining 2" Pipe or Truss    Load Capacity: 1190.5 lb

Related Questions and Answers

Q: 1. The description lists the Conical connector system as being available separately, but the In the Box section lists the truss coming with three connectors and the appropriate pins and clips. Do I need to purchase a connector set to join two truss sections?

A: To connect another M222 section to this section, you only need 2 conical connectors. Having said that, this section includes 3 connectors, two for combining the sections and one spare.

Q: 2. Can it lock to connect two parallel pipes?

A: Yes, this is for attaching pipes that are perpendicular/right angle or parallel to each other.

Q: 3. What materials is this made of? Aluminum or Plastic?

A: The Impact Grip Head For Wide Diameter Tubes would be aluminum.

Q: 4. Can this clamp expand to fit over a 2 1/4” dia. pipe?

A: All of our clamp are designed around a 2" diameter tube. Since 2-1/4" diameters are not common in the trussing industry, I cannot confirm the fit.

Q: 5. Will this secure pipes smaller than 2" (ie. 1&3/4")?

A: Pipes that are smaller than 1.75 inches will not be tight in the Global Truss Heavy Duty Dual Swivel Clamp for 50mm Tubing.

Q: 6. What is the minimum and maximum size of rods this clamp can connect?

A: The Avenger eye couplers have a clamp range of 42-52mm

Q: 7. Is this clamp compatible with 1.5" speed rail?

A: No the Global Truss Heavy Duty Dual Swivel Clamp for 50mm Tubing is suited for 2" rail.

Q: 8. What is the maximum weight rating for this structure?

A: As per the manufacture. This item can easily support 1,000 Lb. of uniformly distributed load on each side of this structure without question (hence 4,000 Lbs. total if all four sides are loaded).

Q: 9. Is it safe to use this charger with the AX1 tubes?

A: No. The following unit is designed and made for helios and titan tubes only.

Q: 10. What it the max hanging weight limit on this

A: The Milos QuickTruss ULTRA Display Square Truss Kit (13.0 x 13.0') technically, if the system was being used indoors, on level ground cable of supporting the loads being applied, then the system could support as much as 2,900 Lbs. per 4m side, for a combined load of 11,600 Lbs. on the total system. This is based on a uniformly distributed load across each of the 4m spans of truss (so things like cables, drapes, etc.). If a large point load is preferred then the user could apply a single point load of 2,500 Lbs. anywhere on each side (so 10,000 Lbs. total if that load was applied to each of the 4 sides). This also assumes that the loads can be applied in such a way as to not damage the members of the truss (suitable clamps, slings, etc.). Outside use there are way more variables and best is to contact the lighting department in chat.