The Aquatica SURVEYOR Moisture Alarm for Canon EOS 1DX Mark IIfrom Aquatica SURVEYOR Moisture Alarm for Canon EOS 1DX Mark IIoffers an added level of protection to the underwater photographer. The SURVEYOR circuitry integrates a water detection function that remains on constant duty when a battery is inserted. Should the slightest amount of water make contact with the sensor probes, it will trigger an alarm using both an audible signal and a rapidly flashing red LED to visually attract your attention. Adding the vacuum pump and pressure valve to your housing will make it possible, by creating a vacuum inside the housing, to fully test its sealing integrity. Once the easy-to-follow procedure is completed, a green LED blinking every five seconds will inform you that your SURVEYOR system is monitoring your camera housing and you're ready to dive. In the event that sand, hair, or other foreign matter would compromise the housing sealing integrity, the SURVEYOR warns you with both an audible signal and a rapidly flashing red LED signal.

This kit includes the moisture and vacuum sensor circuit, a pressure valve with retaining nut, a vacuum pump, mounting hardware, a container of O-ring lubricant, and a CR2032 battery.

Red Flashing LED When Water is Detected    Vacuum Pump to Verify Seal Before Dive

Related Questions and Answers

Q: 1. About the material of this grip does it feel the same with the body (leather/rubber) and are the color the same?

A: Yes, the grip will feel and look the same as the rest of the camera body.

Q: 2. will this work with the RRS BH-40 full lever ballhead?

A: The RRS full lever ballhead requires an RRS L bracket to be 100% secure. I wouldn't recommend an L bracket from a different manufacturer if you want to be 100% secure.

Q: 3. Is the Kirk L Bracket QD System strap mount same as the one for RRS QD System? Thanks.

A: The QD System strap mount is the same on both Kirk and Really Right Stuff L brackets.

Q: 4. Will this cage work if I want to use the Canon DM-E1D mic on the R6mkii?

A: Yes, the SmallRig Camera Cage for Canon EOS R6 Mark II can fully accommodate the Canon DM-E1D Stereo Microphone.

Q: 5. Was wondering if anybody uses this grip with an arca-swiss type plate and tripod? Does it feel solid?

A: Yes, we have. We purchased the Acratech plate for this grip and it is rock solid. We did call Acratech 1-909-392-7522 before purchasing to be sure we had the correct plate. They were great on the phone and I received the correct plate so fast.... Fabulous! and super rock solid!

Q: 6. will it work wth 6D?

A: No, it is only for the Canon 6D II.

Q: 7. Does the grip add a lot of weight to the camera?

A: If you connect the Vello Battery Grip for EOS 6D Mark II and attch a 2nd battery to the unit, you would be addidng approximately 13 onces to your camera weight.

Q: 8. Does the grip with AA batteries change the shutter rates? (frames per second)

A: I never use AA batteries

Q: 9. Can you power the Anton/Bauer P-Tap to LP-E19 Regulated 10.8V Dummy Battery for Canon 1DX/1DX Mark II with a Bolt cyclone/DR PP-400DR

A: No, you cannot power the Anton/Bauer P-Tap to LP-E19 Regulated 10.8V Dummy Battery for Canon 1DX/1DX Mark II with any power accessory that doesn't have a D-Tap.

Q: 10. Do you happen to know whether its weather-sealed? Especially around the insert section of battery compartment? Thanks

A: This product is not weather sealed.