The Large Magnet Grip Mount with 50mm Stud & 6" Baby Pin Adapterfrom Large Magnet Grip Mount with 50mm Stud & 6" Baby Pin Adapteris the ideal way to mount light fixtures, grip gear, and camera heads onto a car or any metal surface where you'd like to position your equipment. This magnetic mount features an industry-standard 3/8"-16 mounting stud to hold whatever gear or fixtures are needed to get that incredible motion shot.

The MGM-100 is outfitted with powerful rare-earth magnets that have a pull force of up to 100 lb, so grip gear, camera mounts, and other gear will be secure and won't slip out of place when shooting the action while driving, boating, or snowmobiling. The 5.3" diameter base features a rubber coating that adds traction and resists scratching or damaging the surface it's mounted on.

The MGM-100 will securely hold a camera or grip accessories, and multiple mounts may be used together for larger setups. As a car mount, there are endless possibilities of light and camera placement for adding dramatic, stunning driving sequences to a video.

5.3" Magnet Grip Mount with 3/8"-16 Stud    6" Baby Pin with 1/4"-20 and 3/8"-16 Tap    50mm Long 5/8" Stud Adapter, 3/8"-16 Tap    Rare Earth Magnet, 100 lb Pull Force

• Mount grip gear on a car or any metal surface
• Also ideal for light fixtures and ball heads
• Magnets with 100 lb vertical pull
• Rubber coating prevents scratches
• 3/8"-16 threaded stud
• Stable base with a 5.3" diameter

Related Questions and Answers

Q: 1. Does this have a flat on the side of the stud? If not, is there a similar product that does have that?

A: The top of the stud is flat.

Q: 2. Is this mount compatible with the smallhd 4k 13" monitor?

A: Yes, the E-Image VESA to 5/8" Baby Pin Adapter Female is compatible with the SmallHD Cine 13 UHD 4K High-Bright Monitor.

Q: 3. Would Godox 600BM fit on Mathews C stand ( turtle base) using this? Thanks

A: Most Godox flashes will fit most c stands without an adapter

Q: 4. What is the thread type of the 3/8" female side? 16 or 24 thread per inch?

A: 3/8 - 16 is the standard size for these products

Q: 5. What thread size is the tapped hole on the spigot?

A: The Kupo Baby 5/8" Receiver to Stud Adapter for Elinchrom Heads has a 1/4"-20 female receiver on the top of the spigot.

Q: 6. Are the pins collapsable for mounting a ball head on the screw?

A: No, the pins on the amaran Baby Pin Adapter to 3/8"-16 Screw are not collapsible.

Q: 7. Is the junior pin the same length as the Avenger adapter? The Avenger adapter is too long to fit in Matthews 4.5 grip heads.

A: I think there are different lengths. Technically the Junior designation is only about the diameter

Q: 8. Your listing says the minimum jaw diameter is 1.9". Is that true? Is it not compatible with 1-1/4" (1.66" OD) aluminum pipe?

A: The Kupo Slim Type Half-Coupler with 5/8" Baby Stud will fit tubes 48-51mm (1.88-2.0") in diameter.

Q: 9. Would these fit an impact turtle base?

A: This would fit the Impact turtle base.

Q: 10. Does it come with an O-ring?

A: Yes. The following comes with a o-ring.