The Laird 72" Power Cable from TecNec features a 2-pin LEMO connector at one end and a 2-wire flying leads end at the other. This can be used to power many Teradek devices.

Two-wire flying leads end

Works with Bolt, Bond, Link, and many Cubes

Laird Equivalent for Teradek BIT-218 cables

Related Questions and Answers

Q: 1. Can this work to power the Small HD cine7 monitor? I see someone has asked about indie7 but just wanted to check. I know they list it as for something teradek cube, etc. but what makes it different that it wouldn't work on the cine7?

A: This cable can power the SmallHD Cine 7 monitor. 2-pin LEMO cables are cross compatible with different brands that have a 2-pin LEMO port.

Q: 2. What size is the barrel end?

A: The barrel end is a 5.5x2.1mm, center-positive barrel jack.

Q: 3. Can this be used to power a Bolt 6 Tx?

A: Yes, the Teradek 18W AC Adapter to 2-Pin LEMO (6') will power the Teradek Bolt 6 TX and RX

Q: 4. Would this cable power a non-Teradek brand, 2-pin lemo device? Specifically, a different brand video transmitter.

A: There should be no issue at all. However, prudence dictates that you should check the polarity of the connections before hooking it up.

Q: 5. Would this work to power the Tilta Power Supply Base Plate for DJI Ronin RS 3 Pro?

A: The Teradek 2-Pin LEMO to AC Adapter Cable (6 ft) will not supply sufficient power to the Tilta Power Supply Base Plate for Select DJI Gimbals.

Q: 6. This ok to use on Teradek Cube? Thankssss

A: Yes, this meant for most any Teradek device.

Q: 7. Would this work as a power supply on a ZCam E2 S6?

A: Yes, the Teradek 2-Pin LEMO to AC Adapter Cable (6 ft) is compatible with the Z CAM E2-S6 Super 35 6K Cinema Camera (EF Mount) since the Teradek and Z Cam share the same pin 1 as ground.

Q: 8. This should be included in every Bond or Cube device, isn't it? Do I need to buy this separatelly to operate BOnd/Cube without battery? AC I mean

A: If you wish to use the Bond or Cube on AC only, yes this is what you need. Because everyone's needs are different, manufacturers offer some accessories as options. Thus people who only use batteries are not stuck with AC power adapters they do not use nor are people who only use AC get batteries that clutter up their closets.

Q: 9. Purchased this for Bolt 1000 Transmitter/Receiver. What I received was a power supply with a 12V/3A output. Is this the right part?? My original is 9.0V/2A. I don't want to fry anything.

A: This is a power cable created by Teradek specifically for their Cube, Bolt, Bond and Link products. It should work just fine with your Bolt 1000.

Q: 10. can you power the new SMALLHD INDIE 7 monitor with this cable?

A: No you can not. You should use this to power the Indie 7 Monitor instead. SmallHD D-Tap to L-Series Dummy Battery Cable (32") BH #SMDTSLFB • MFR #PWR-ADP-SONYL-DTAP