The BNC Female to BNC Female Adapter - Pearstonebridges together two BNC male connectors. This 50-ohm connector supports SDI signals up to 6G-SDI.

Bridges Two BNC Male Connectors

Related Questions and Answers

Q: 1. Does this fully support Dual Link of DVI-D? (or just single link)?

A: Technically the Pearstone DVI-D Female To HDMI Male Adapter's connector itself is dual-link, but it is limited by its HDMI interface to supporting only single-link resolutions.

Q: 2. Will this work as a generic adapter or must it be used with the TVOne switcher?

A: The TV One DVI Male to BNC Female Adapter is compatible with the C2-6000 & C2-8000 Series universal input seamless switchers.

Q: 3. Can I use this to extend a SDI cable run?

A: The Pearstone BNC Female to BNC Male Right-Angle Adapter (B&H# PEABNCB1R) will connect to one female-end BNC and one male-end BNC. As such, if you somehow have an SDI cable with a female end (extremely rare) then you could theoretically use this for that purpose if the other end of that same cable is male. However, in all likelihood (you'll want to check), both of the ends of your cable are male. For that reason, you'll need a double-female connector to connect two cables that have male BNC plugs. Here's a good option for up to 6G-SDI: Pearstone BNC Female to BNC Female Adapter (B&H# PEABNCD1) https://bhpho.to/3PCtlyB

Q: 4. Will this work with an HDMI-Fiber cable back to a switcher? I.e., any issues with signal strength when introducing the adapter?

A: There should be no problem using this adapter with an HDMI fiber cable.

Q: 5. Can it work as a timecode BNC cable from Zoom H8N to Sony fS7?

A: Yes, this cable can work as a timecode BNC cable from the Zoom to the FS7. However, you will need the XDCA-FS7 extension unit https://bhpho.to/2Rb47xk attached to the camera, as you cannot sync with BNC directly to the camera.

Q: 6. Is this cable fairly flexible, or more rigid? Looking for something flexible and easy to wrap up.

A: Flexible and easy to get 1' diameter coils...

Q: 7. How is this adaptor wired? We assume BNC "hot" goes to XLR pin 2, but is XLR pin 3 floating or strapped to XLR pin 1? Can we alter the internal wiring?

A: According to Neutrik, the NA2FBNC is wired so that XLR pin 2 is hot and pins 1 and 3 are wired to ground. The internal wiring on the adapter is not intended to be reconfigured. For more information about the wiring, please contact Neutrik directly. Their US office is located in Charlotte, NC and you can reach them by phone at 704-972-3050.

Q: 8. Is this adapter RoHS compliant?

A: The documentation does not show that it is RoHS compliant.

Q: 9. What is the ohms on this connector?

A: I am afraid that the exact Ohm rating of this connector is not listed by Pearstone. However if you must have 75 Ohm we have a similar angled connector from Comprehensive that is specifically rated at 75 Ohm and does not cost that much more. B&H # COABMBFRA will work very well for you.

Q: 10. I’m looking to attach an old Wacom Cintiq 22hd (dvi d) to a new M4 mac mini (hdmi port) with this. Should this work?

A: The Pearstone DVI-D Female To HDMI Male Adapter should be compatible with the Cintiq 22HD.