The American DJ 5-Pin to 3-Pin DMX Turnaround Cableis a problem solving adapter for professional lighting and special effects installations. With the turnaround cable you will be able to interface with lights, fog machines, and other DMX capable devices that use either 3-pin or 5-pin DMX XLR connectors and cables.

For Wiring Lights and Special Effects    22 AWG    Shielded Cable

Related Questions and Answers

Q: 1. Is this used for powering a GVM light using a battery? If not, can you suggest a way to power a GVM300 using a Li-ion battery?

A: The GVM DMX 3-Pin XLR Y-Cable (20") BH #GVMDMX20 is for DMX control. The GVM300 is not suitable for use with batteries.

Q: 2. Is there a way to turn on sound active mode when in DMX mode?

A: Sound activation mode is only adjustable on unit itself.

Q: 3. Wire Gauge? AMP current capacity? Shielding type?

A: The following cable is a 24 awg cable which is shielded and can support a current amp capacity of 14.2 amps.

Q: 4. Is this compatible with the Luminair app?

A: This device has a dedicated app iOS Airstream DMX Pro app.

Q: 5. Is this only for LED lights?

A: The ADJ Stage Pak 1 Controller & Dimmer Pack System can be used for tungsten lamp heads as well as long as they do not exceed the 1800 watt limit on each dimmer pack.

Q: 6. Could this cable be used with the Aputure 120D II, connecting the power unit to the light fixture?

A: Yes. the power connection is 5 pin XLR. XLR cables come in different gauges. The American DJ cable is not a heavy gauge. It might heat up and be inappropriate. Best to go with a heavier guage.

Q: 7. Does this console work with 3 pin XLR DMX fixtures?

A: The American DJ DMX FX512 Lighting Console can be used with 3pin XLR and you will need the adaptor https://bhpho.to/4aB86Y2.

Q: 8. do you Daisy-Chaining them?

A: yes you can daisy chain the dimmer packs

Q: 9. Does the ADJ Pinspot Quad change colors automatically without DMX?

A: Yes, the American DJ Pinspot LED Quad DMX has auto modes and sound activation.

Q: 10. When using several of these can I sync them? For example, if I place units on the same DMX channel, set the speed to 4 flashes per second and then enable them by setting the intensity from 0 to my desired level will they begin flashing at the same time and maintain synchronization? Alternatively, can I control individual flashes by setting a slow flash rate and then retrigger by setting intensity to zero and then back to get a "flash on demand"?

A: According to the manufacturer when on a control board they will sync and act as one unit.