Compatible with EW-DX wireless receivers, the Sennheiser EW-DX TS 3-PIN Wireless Transmitter 520-607 MHzis a digital wireless tablestand transmitter with a 3-pin XLR input connector designed to accommodate a wide range of Sennheiser gooseneck microphones equipped with a 3-pin XLR output connector.

Ideal for use where wired mics are impractical, this tablestand transmitter is designed for quick setup and tear down, and can be put away on the CHG 2W inductive charging station (available separately) for in-device charging the included BA 40 battery when the transmitter is not in use.

Use with EW-DX Digital Wireless Receiver    For Sennheiser 3-Pin XLR Gooseneck Mics    134 dB of Dynamic Range, 24-Bit Audio    3480 Frequencies on Equidistant Grid    Programmable Mute Button    Secure AES-256 Encryption    Durable Metal Housing    Inductive Charging    11-Hour BA 40 Rechargeable Battery

• The mute button can be configured for Momentary or Push-to-Talk/Push-to-Mute operation, with a bicolor LED indicating the mute status.
• The button can be locked out and overridden from the receiver or a mobile device during a talk.

• The EW-DX TS 3-PIN is equipped with a 3-pin XLR input connector for Sennheiser 3-pin XLR gooseneck mics.
• The transmitter operates up to 11 hours on a fully charged BA 40 lithium-ion rechargeable battery pack (included)—inductive charging with CHG 2W Wireless Power Transmitter (available separately).
• AES 256-bit encryption offers a secure transmission.
• With 134 dB dynamic range on its input, the tablestand transmitter can easily handle loud and soft voices without requiring any gain adjustment.
• The EW-DX system utilizes an equidistant tuning grid that equally spaces 3480 frequencies across its wide 87 MHz bandwidth to prevent disruptive intermodulation issues that occur when multiple transmitters operate in confined spaces.
• The system can be expanded with multiple transmitters and receivers to offer up to 146 channels in equidistant tuning grid mode, and up to 293 channels in Link Density mode.
• The EW-DX TS 3-PIN is backward-compatible with EW-D receivers.

Related Questions and Answers

Q: 1. Can you use this system with an analog EW100 system for panel discussion or is the delay going to cause out of sync problems?

A: The Sennheiser EW-D 835-S SET Digital Wireless Handheld Microphone System has a latency of about 1.9 ms, so the offset will not be substantial when used alongside an analog wireless system.

Q: 2. If I was to build a 4 unit system for panels discussion, how would I identify each mic without it having a display?

A: The Sennheiser EW-D 835-S SET Digital Wireless Handheld Microphone System can be labelled with the Sennheiser EW-D COLOR CODING SET (BH #SEEWDCCS).

Q: 3. Can I use these with an antenna distribution system, instead of the shark fin style? So 4 receivers would be patched into 1 of these antennas...

A: An antenna of this type would not be recommended for a distribution unit. They are designed to be used as a pair with a single receiver, and will not work properly connected to an antenna distro carrying multiple signals.

Q: 4. Will this plug-in transmitter work with the EW-DX line of receivers? I'd like to replace my EW receivers and SKP2000 transmitte

A: No, the Sennheiser EW-DP SKP Digital Plug-On Wireless Transmitter/Recorder is not compatible for use with the Sennheiser EW-DX series receivers.

Q: 5. Can this be bound to EW-DX receivers?

A: Yes, the Sennheiser EW-DP SKP Digital Plug-On Wireless Transmitter/Recorder can be paired with [Sennheiser EW-DX wireless receivers that operate within the same frequency band.

Q: 6. How does it compare to wireless G4 500P?

A: The Sennheiser SKP 500 G4 Pro Wireless Plug-On Transmitter uses analog UHF wireless technology for transmitting audio and has an RF bandwidth of 88 MHz with 3,520 frequencies while the Sennheiser EW-DP SKP Digital Plug-On Wireless Transmitter/Recorder uses digital UHF technology and has an RF bandwidth of 56 MHz with 2, 240 frequencies. The EW-DP SKP also functions as a digital audio recorder.

Q: 7. Will it work with the Sennheiser EK 500 G4 Pro Wireless Camera-Mount Receiver AW+: (470 to 558 MHz)?

A: The Sennheiser EW-DP SKP Digital Plug-On Wireless Transmitter/Recorder (Q1-6: 470 to 526 MHz) will not work with the EK 500 G4 Pro Wireless Camera-Mount Receiver. However, the Sennheiser SKP 500 G4 Pro Wireless Plug-On Transmitter AW+ (BH # SESKP500G4AW) will work.

Q: 8. Can multiple transmitters be paired with a single receiver? Similar to the Sony UWP system.

A: No, the EW-DP EK receiver is single-channel only and only one transmitter can be connected at one time.

Q: 9. Is this digital Wireless Transmitter compatible with the Sennheiser analogue system with the same frequency bandwidth?

A: The Sennheiser EW-DP SKP Digital Plug-On Wireless Transmitter/Recorder is not compatible with older analog models of Sennheiser wireless receivers.

Q: 10. In terms of audio quality for streaming (using a Rode Caster Pro II), is it better to use SKP 500 G4 or EW-DP SKP?

A: The Sennheiser EW-DP SKP Digital Plug-On Wireless Transmitter/Recorder and the Sennheiser SKP 500 G4 Pro Wireless Plug-On Transmitter both require their compatible wireless receiver, as well as a microphone, in order to function. Both systems will provide high quality audio when used with the RODE RODECaster Pro II Integrated Audio Production Studio. One system would not necessarily be better than the other.