Offering higher impact resistance and enhanced rigidity compared to standard PLA materials, you can print a wide range of items with Polymaker 1.75mm PolyLite PLA Pro Filament, allowing you to create operational prototypes, real-world use items, and more.

Derived from corn starch or sugar cane, this durable Polylactic Acid (PLA) material provides a recyclable, natural, thermoplastic polyester suitable for printing a litany of creations. PolyLite PLA has a printing speed range between 30 to 70mm/s and a printing temperature range of 374 to 428°F as well as a bed temperature range of 86-140°F. This filament supports direct and indirect drive systems with a retraction distance and speed of 1mm at 30mm/s and 3mm at 60mm/s, respectively. Each spool and box is made from recycled material, ensuring a positive impact on the environment.

1.75mm Filament Diameter    1kg Weight    30-70 mm/s Printing Speed Range    374-428°F Print Temperature Range    86-140°F Bed Temperature Range    Direct & Indirect Drive Compatible

Related Questions and Answers

Q: 1. "Center column is removable, which allows the tripod to be set at a minimum height of 4.9" How can it be used without the center column, unless there is a short one available to take its place?

A: The center column splits near the top, turning it into a short center column.

Q: 2. Is the center column removable and if so then how low it can go to the ground?

A: With the Slik Pro CF-733 Tripod (Black) one can remove the lower part of the center column to get lower to the ground. One can then get down to 8.3" (This does not include the height of any head one may use). Alternatively one can invert the center column to get even lower to the ground.

Q: 3. How much clearance (from desk to bottom of screen) does this monitor have when fully extended?

A: The MSI PRO MP251 24.5" Monitor (Black), BH #MSPROMP251, does not extend in height. The height between the bottom of the monitor to the desk is roughly 3.73 inches.

Q: 4. Will my Benro GD3WH 3-Way Geared Head mount to this ?

A: Yes, the Benro GD3WH 3-Way Geared Head is compatible with the Slik 700DX Pro Tripod Legs (Titanium Finish).

Q: 5. What is the diameter of the base plate (where the head attaches)? Would the manfrotto befree video head fit on this neatly, says it is best that it be a 40mm base plate?

A: The base plate is about 2" wide, and would fit the Manfrotto BeFree video head quite nicely on it.

Q: 6. Will it also accomodate the Anova Pro v. II? Also, how many batteries?

A: It Will fit previous versions of Anova V2 if Replacement YOKE (RL-ANVPRO-YOKE) also purchased. Including batteries in the case may be difficult.

Q: 7. I need a quick release plate for the slik Pro 700DX. It's not listed in accessories. Any suggestions.

A: George I use this tripod with a ball head and the following release plate assembly: Manfrotto 323 RC2 System Quick Release Adapter with 200PL-14 Plate. I have a couple of tripods and have installed this system on them.

Q: 8. Hi, does it works with an Ipad?

A: The Boox Pen2 Pro (Black) BH #BOOSL0051R is not compatible with an iPad.

Q: 9. shipping?

A: You may calculate your actual shipping options/order totals by adding the items you want to a shopping cart. It will then list the shipping options, descriptions, ETA's and fees to your location.

Q: 10. Is this made in Thailand or China?

A: This tripod is manufactured in Thailand.