Increase the visibility of your production monitor when filming outdoors with this Lilliput Sun Hood BM230 Series Monitor Coverfrom Lilliput, specifically designed to fit BM230 series monitors. It can easily be taken on and off thanks to its snap-on construction. The shade shields the sun from your monitor's surface so it can still be viewed, even in full daylight conditions.

For Lilliput B230 Series Monitors    Increases Monitor's Visibility    Easy to Install and Remove    For Outdoor Daylight Conditions

Related Questions and Answers

Q: 1. Does the 3G SDI support 2160P rasters, or just the HDMI?

A: It does not support 2160P on the SDI side, only on the HDMI input.

Q: 2. Does it work well with the new Focus 7 Bolt Receiver with handles and strap?

A: Yes, this one will work as you desire.

Q: 3. can this monitor be mounted to a C stand?

A: Thank you for your question , the monitor comes with 75mm and 100mm VESA mount holes on the back and consider could be mounted on the C stand,please note the screen weight is 9KG ,thanks .

Q: 4. Do we have an histogram and waveform monitor linked with the different input?

A: Not that we are aware of. According to Lilliput you would need the Lilliput Q17 PRO 12G-SDI Broadcast/Production Monitor for such features, BH #LIQ17. https://bhpho.to/305zv2c

Q: 5. I cannot find any information how to attach the hood to the monitor. It doesn't seem the hood is going to be directly attached to the monitor. Do I need to attach brackets to the monitor and then attach the hood to the bracket?

A: The hardware is included to mount this frame.

Q: 6. Is there a recommended VESA Mount stand to mount this on a desk?

A: The package comes with a set of the metal table stand for the monitor remove from carry-on case, thank you!

Q: 7. How long will a 97Wh battery last?

A: Around 3 hours

Q: 8. What’s the difference between this model with the ‘S’ and the one without?

A: The S version adds the ability to load LUTs (Look Up Tables) into the monitor.

Q: 9. I've seen that the monitor isn't pre-calibrated in previous Q/A, but is it possible to custom calibrate it with the help of a X-Rite i1Display or Datacolor Spyder 5 type of device?

A: Yes, you are able to calibrate the monitor with a X-Rite i1Display or Datacolor Spyder 5 type of device.

Q: 10. Can you pull this out of the enclosure or is it hardwired in?

A: Yes you can easily pull the monitor from the case.. I installed 6mm post with thumb screws to make it quicker to get out.. hope this helps