The Kupo Super Convi Clamp V-Lock Setfrom Kupo features the classic super convi clamp with a V-lock base, an extension handle, and a V-lock wedge. This allows for an easy fit to pipes or tubes with a diameter of 0.2 to 2", or for any device with a V-lock wedge.

Complete All-in-One System    Easy Fit for Pipes    Mounting Solution

Complete all-in-one system that includes a super convi-clamp, a V-lock base, an extension handle, and a V-lock wedge

The convi-clamp makes it an easy fit to pipes or tubes with a diameter of 0.2 to 2"

Related Questions and Answers

Q: 1. Will this hold 1" tube like a C-Stand?

A: This C-Boom Clamp is only for 1-1/4" and 1-1/5" pipes.

Q: 2. Does a c stand fit in this opening?

A: It's mostly meant to be dropped in Large 4.5" Grip Heads. The Kupo C-Boom Clamp for 1-1/4'' and 1-1/5'' Pipes has T-Slotted Ear for mounting. It holds Holds 1-1/4" and 1-1/5" Boom Poles, due to some C-stands made different - you will need to measure your stand to be exact about fitting.

Q: 3. Where is the size measured from? The maximum jaw gap, or the length of the entire clamp?

A: The bolt is 4" the overall length is longer at 8.75".

Q: 4. Will this work with with Manfrotto 208HEX Head Mounting Plate with Hex Stud - 3/8" Thread (BH #MA208HEX) ?

A: No, the Kupo 5/8 - Swivel Super Grip Double Baby Receiver with Ratcheted Handle will not accept the Manfrotto 208HEX Mounting Plate. That plate is only for grip hardware that has a hexagonal slot like a Manfrotto 035 Super Clamp without Stud, BH# MA035. https://bhpho.to/3dApUtZ

Q: 5. How far does the hex receiver stick out? We need it to extend a certain distance from the beam we are clamping onto.

A: It is 2.5" from the notch in the clamp to the opening of the receiver.

Q: 6. Do these swivel so one can clamp horizontal and one vertical?

A: The two superclamps have a fixed position.

Q: 7. Would this ball also work with Ram mounts?

A: The Kupo Super Knuckle Hex Stud Ball for Convi Clamp has only been tested with the Kupo Convi Clamp. Using it with any other mount would have varied results.

Q: 8. Clamp Base, Thread Count for 2 Side Screws? Not 1/4 -20 Center Screw nor Set Screw.

A: The 2 side screws would be an M5 type thread.

Q: 9. How does this product work? It doesnt seem to have a compressing/clamping feature.

A: The two spiked pins would secure the foam core to the clamp using the pre-drilled holes. The clamp then inserts into a standard grip head to hold the foam core in any position needed.

Q: 10. Is the baby stud removable? Or is it welded to the ball head?

A: The baby stud is all one piece the end of the stud is threaded 1/4 20