The Xvive H1 Transmitter Holder for U2 Wireless Systemenables you to attach your U2T transmitter to a guitar strap, distancing it from your instrument's output jack. Physically moving the U2 transmitter further away from your electric guitar helps to eliminate the high-pitched noise that can sometimes originate from active electronics or piezo pickups, or from the integrated microphone in an acoustic guitar.

Protect your U2 transmitter in the H1's leather holster instead of leaving it exposed at the end of your instrument. The top hook-and-loop flap can be passed through your strap's buckle to prevent slippage. Two hook-and-loop straps hold the H1 secure against the guitar strap.

The included 1/4" TS cable extension connects the U2 transmitter to the output of your guitar or bass. It goes through an opening at the unit's lower end that holds the cable in place, ensuring that the U2 doesn't get disconnected.

Holds U2T Transmitter    Distance Transmitter from Guitar    Protective Leather Holster    Attaches to Guitar Strap    Includes 1/4" TS Extension Cable

Related Questions and Answers

Q: 1. Is the internal battery replacable?

A: The internal batteries in the Xvive U3C system are replaceable but the will need to be replaced by the manufacturer or an authorized service center.

Q: 2. Can this be used to connect a mixer with speakers?

A: Yes, the transmitter for the Xvive Audio U3 2.4 GHz Digital Wireless Microphone System accepts line level input signal so the system can be used to connect a mixer with speakers. Keep in mind that this system has an operating range of up to 90 feet line of sight.

Q: 3. Can one transmitter be used to two receivers?

A: Yes, the audio from one Xvive Audio U3T 2.4 GHz Digital Wireless Transmitter can be sent to two receivers.

Q: 4. Can you charge the transmitter/receiver while it is in operation?

A: Thank you for your question. You are unable to charge the receiver or transmitter while it is in use. They do last an average of 5 hours on a full charge to get through most performance situations.

Q: 5. Since this furnishes +48v phantom power, won't this damage a battery powered condenser microphone?

A: The Xvive Audio U3T transmitter does NOT supply +48V phantom power or any type of power at all to a microphone. This transmitter is intended for use with either dynamic microphones (which do not require power) or with condenser mics that use their own separate battery to supply power for the mic. The transmitter's built-in Li-ion 3.7V rechargeable battery is used only to provide power for transmitting a wireless audio signal to the receiver.

Q: 6. Can you run a pair of these for a stereo mic (2 Tx, 2 Rx)? Interference issues?

A: Yes you could run a stereo pair without interference.

Q: 7. Can the receiver be plugged into a mixer that has phantom power activated on all mic channels?

A: Yes. It will not be a problem.

Q: 8. Is the battery on the trans-mitter replaceable?

A: No, the built-in rechargeable batteries for the Xvive Audio U4 Wireless In-Ear Monitor System are not user replaceable.

Q: 9. Can this compatible with other Xvive wireless systems such as the U3? For example, can I use U3 transmitter with U4 receiver on the same channel?

A: Yes, according to Xvive, it is possible toa use a U3 transmitter with a U4 receiver when both units are set on the same channel. Xvive has a video posted on their Facebook page that shows the setup in use: http://www.facebook.com/xviveaudiousa/videos/can-a-u3-transmitter-work-with-a-u4-receiver-heres-live-proof-that-you-can/2287201628250839/

Q: 10. Is this bootable as a RAID 10?

A: Yes, the OWC U2 Shuttle can be configured in RAID 10.