Add a powerful but compact, high-power linear RF amplifier to your TV broadcast platform with this 30W High-Power Amplifier 500 MHz-2.5 GHz RF-Linksfrom RF-Links. The solid-state amplifier has been designed for military and commercial broadcast applications and it provides over 55 dB gain, 50 ohms input/output impedance, and 25–30W RF power output. It supports transmitters in the 500 MHz to 2.5 GHz broadband frequency range. This unit features SMA female input and output.

High-Power Broadband RF Amplifier    For Military and Commercial Applications    25-30W Power Output, 55 dB Gain    500 MHz to 2.5 GHz Frequency Range    50 Ohms I/O Impedance, SMA Connectors

Ideal for military and commercial broadcast applications

500 MHz to 2.5 GHz frequency range

25–30W output power

Compact, lightweight, rugged, and reliable

50 ohms input/output impedance

Requires external heat sink for cooling

Related Questions and Answers

Q: 1. How wide? Can I use 1" webbing or only 3/4"? What is the difference btw V3 and V4? How can I identify the diff on box?

A: Peak Design AL-4 Anchor Links housing has 2 holes. the smallest one is 1.2 x .32 cm, the largest is 32 x .32 cm. Therefore any webbing would fit through them. The V4 has a thick cord and the logo is only in one side compare to the V3 anchors.

Q: 2. Will this work for the Sony A73 original strap in that camera?

A: Yes. The following anchor set will work with the Sony a7 III Mirrorless Cameras.

Q: 3. Do u have agent in Nigeria ?

A: Our only location is in New York City, in the United States.

Q: 4. Would these work with a Leica strap that has permanent metal rings on the strap?

A: Yes. The following unit offers eyelets in order to attach via " o" rings.

Q: 5. How can i connect an cdmi cable to this device? Is there an adaptor?

A: You can use this Atomos Connect H2S Converter. It is great for a camera needing to be mobile. For permanent situations, you could use the KanexPro HDMI to 3G/HD/SD-SDI Converter.

Q: 6. Are the anchors strong enough to carry a Z9 attached to a 400 F2.8 lens?

A: Each anchor can withstand over 200 lbs of force so it will easily support a large camera and lens such as the Nikon Z9 and the 400mm f2.8 lens.

Q: 7. Where is this unit manufactured, as labeled on the unit? Please no opinions, just facts.

A: The Toa Electronics CA130 30W Mobile Mixer Amplifier with Microphone is manufactured in Indonesia.

Q: 8. can they be used with optech's camera straps?

A: Yes, we suggest the following strap for such a application. OP/TECH USA E-Z Comfort Strap (Black) BH #OPSEZCB • MFR #2701252 https://www.bhphotovideo.com/c/product/118815-REG/OP_TECH_USA_2701252_E_Z_Comfort_Strap_Black.html

Q: 9. Is this a Bluetooth transmitter or only a Bluetooth receiver?

A: This is a Bluetooth receiver only.

Q: 10. just how good is this amp? give me a comparison .

A: This model is known for its very low self noise and high signal to noise ratio using Benchmark's DAC3 digital to analog converter. It is also known for its ability to output at higher levels without introducing distortion into the signal. Further details can be found on the AHB2 product page on Benchmark's site, linked here: https://benchmarkmedia.com/products/benchmark-ahb2-power-amplifier