Flic Film UltraPan 400 35mm Roll Film 36 Exposuresis a panchromatic black and white negative film with a nominal sensitivity of ISO 400/27°. Its good resolution and exposure latitude make it ideal for lower light shooting conditions.

Panchromatic B&W Negative Film    ISO 400/27° in Standard Process    35mm Film, 36 Exposures    Broad Dynamic Range    Ideal for Mixed Lighting Conditions

Related Questions and Answers

Q: 1. what's the developing time for this film using Kodak X-tol developer, I used hoya R72 filter

A: I don't know the effective reduction of your filter, but for an effective ASA of 50 a 1+1 dilution at 20 degrees C and a time of 7 1/2 minutes should suffice.

Q: 2. I have an old (1986) Minolta 35mm film camera. Will this film work in that camera?

A: The following Minolta cameras have an infrared film counter, which will fog (pre-expose) infrared film: Maxxum 70, 50, 7, 5, 4, 3, XTsi, HTsi, HTsi Plus, STsi, QTsi, 300si, 400si, 500si. Older Minolta cameras such as the SRT101 and similar mechanical cameras can be safely used with infrared film.

Q: 3. How many exposures does this film roll have available to be shot?

A: The Flic Film Vision3 200T Cine Film (35mm Roll Film, 36 Exposures) contains 36 exposures.

Q: 4. If you used an 850 IR filter with this film would you still get an image or would it just block all light?

A: Rollei infrared is only sensitive up to 850nm. So anything that's blocks 850nm and down prob won't produce an image. I use a Hoya 72 filter with this film.

Q: 5. Will the outcome with a Lee #87 be comparable to a screw on r72 filter (Lee better with multiple lenses)?

A: Yes, I believe the 72 filter is just as good to use as the 87 filter. I hope that helps.

Q: 6. Many people are saying that they're using a r72 IR filter. Why do you need this if the film is sensitive to only IR?

A: To get the full effect if IR, a filter is needed, that has always been the case. A deep red filter enhances the infrared effect.

Q: 7. Is this film sensitive to the wavelenhth at Hydrogen Alpha (656.281 nm) what are its reciprocity characteristics and is it generally useful for astrophotography?

A: Rollei INFRARED has an infrared range of (650 – 750nm). According to Rollei, the reciprocity is 1.43. IR film needs IR light which is more available during the day. Shooting it at night would be experimental.

Q: 8. For developing Bergger Pancro 400, I will be using Sprint Standard developer. For 400 ASA, can anyone give me some idea of the developing time (for example at 68 F.) either from experience or time used on other developer I can compare? Bergger says they have no idea since don't use Sprint in Europe. Thanks

A: I have never used Sprint or seen it in USA. I use D76 or ID11 if that is what is available. I mix D76 myself from purchased components. Berggers time seem to be very accurate if you have an accurate thermometer and use their suggested agitation cycle. You might try to interpolate time from something else, say tri x D76 1:1 which is 9 minutes at 68F / 20 C. Bergger 400 is double that.If you are unable to do above, the only other option is to do it by test which can be painful without a starting point. The way to do it is shoot 6 exposures if a subject with full tonal range black to white and is repeatable. I use a studio set up with strobe which is always the same.Cut off 12 in/30 cm and develop that. The is no difference in long or short rolls. In any case you will probably need to adjust any time to your paper, enlarger, condenser or diffusion, thermometer error, water, scanner etc. There are many variables. What is important is you actually print or scan ( whatever is your end product) and not use your eye as the negs appear somewhat flat compared to other films. However they seem to print or scan perfectly.Since the development times are so long, you may use 75F without a problem. My first tests were done that way as that was my ambient temp in the middle of a heat spell. I like iso 200 for the extra shadow detail. cut the 400 iso development time by 15% If your first tests are lacking contrast, use longer times. Less if to much contrast.Should you elect D76, I can be a finicky developer. Allow to cool after mixing 24 hours before use. Use small one time use glass bottles, 4 oz in my case. It does not last even a week in partially full containers. FORGET THE 6 WEEKS KODAY SAYS. Ph goes up then down and development time is unpredictable. This happens within days.In full air tight bottles, it lasts 6 months after which activity decreases slowly. I have taken careful measurements to determine this. Kodak agrees with 6 months. I do not use premixed developers as I have no idea how old they are or how long they were on a store shelf. There is a website called emulsive which ran a 3 part series on this new film. I suggest you look at it. Up to 7 now. I am behind.Bergger has a pdf link on their website with much info similar to what Kodak had when they were a profitable company. Do your best to push thru the experimentation . This a beautifully toned film and I am not a fan of fast films like HP5 and Tri x. It has grain but not excessive, but neither as smooth a TM100 or Delta 100. Iso 200 17 min at 68F agitation 5 sec every 30 condenser enlarger, grade 2 paper. Leica V35 requires Normal + 1/2 grade.200 iso 10 min at 75 deg for condenser Focomat 1C. Do not reuse developer if you are experimenting.HC110 is on the the PDF and is a good alternative. Use 1:31 and mix as required. Use dropper or transfer pipette and graduated 10 cc cylinder to

Q: 9. Would this film work for IR flash photography at night with an infrared flash?

A: Rollei Infrared 400 Black and White Negative Film (35mm Roll Film, 36 Exposures) is suitable for night photography with an infrared flash.

Q: 10. is it fresh film?

A: B&H Photo's policy on film is that all film sold will have an expiration date at least 6 months after the delivery date.