The Matrix Switch MSC-FC1F4B-1 1x4 Fiber to 3G-SDI BNC DAfrom Matrix Switch MSC-FC1F4B-1 1x4 Fiber to 3G-SDI BNC DAcan be used to output a single fiber input to up four 3G-SDI BNC outputs. This compact DA supports up to 2K25, 4:4:4, 10-bit video signals via a single-mode SMF LC fiber cable at distances up to 12 miles. The converter includes one SFP fiber module and an external power supply.

1 x SFP Fiber Input    4 x 3G/HD/SD-SDI Outputs    Includes 1 x LC SFP Fiber Module    Reclocked SDI Outputs    Supports SD, HD & 2K Signals    Up to 4:4:2/4:4:4 10-Bit Video    Auto Bypass of Non-Standard SDI Rates    Passes Embedded Audio & Ancillary Data    Up to 12 Mile Range    Includes 1 x 5V, 2A Power Supply

Related Questions and Answers

Q: 1. Will this work with an HDCP source?

A: HDCP compliance is not explicitly defined by manufacturer. Please contact directly for expedited attention to your inquiry - https://bit.ly/35iC7fZ

Q: 2. How long will this run on 1 fully charged battery?

A: That really depends on what batteries you plan on using....

Q: 3. Has anyone measured latency of the SDI version vs the HDMI version on the same camera? Curious if the SDI version has significantly less delay.

A: No it does not. the delay from the camera to the Newtek Spark is almost non existent when compared to the delay that happens when converting a video signal to be sent across a network and the bandwidth limitations of said network. If you purchased both the SDI and HDMI versions and hooked them up to a cameras on the same network you should experience the same delay.

Q: 4. Will this work with SDI signal?

A: No it will only work with Composite Video.

Q: 5. There is no mention of the video bit-depth. What is it? Does it support HDR?

A: The Vizrt Spark Plus I/O 12G-SDI Converter is an encoder; therefore, the video will get compressed to 8-bit H.264/H.265 when sent across the network. You can send in a 10-bit HDR image if you like; just be aware that the NDI encoding process will compress the image to 8-bit.

Q: 6. is this 50 Ohm or 75 Ohm?

A: Since this is for Composite video signals and not for power or control, the unit is 75 Ohm.

Q: 7. does this work for the Sony handyman ?

A: I assume you mean the SONY Handycam, Fabio,; yes it can be used with the Handycam - you just need a ball head or Quick Release Clamp in between (just like with a still camera).

Q: 8. Does this device decode one NDI stream and encode another NDI stream at the same time?

A: This item BH #NENSP4KIO will only support one NDI signal at a time.

Q: 9. What is the total power consumption in watts for POE use?

A: The NewTek Spark Plus I/O 4K uses the 802.3af PoE standard and requires 15.4 Watts of power. POE AF injector idea - https://bhpho.to/3Xjmqy6

Q: 10. Can a D-tap to 4 pin XLR cable power this monitor from a V-mount battery?

A: Yes, You can power the Lilliput 7" 3G-SDI Field Monitor using a dtap cable which connects to the XLR power input. BH #KODTAP4XLR