System installers looking for a cost-effective network power amplifier will be impressed with the Bogen Nyquist NQ-A4300-G2, a 300W per channel quad networked audio power amplifier well suited for permanent installations and commercial sound applications. The amplifier is designed to meet the rigorous requirements of today's sophisticated sound systems.

The Nyquist amplifier provides unparalleled flexibility and versatility. The integrated DSP software provides extensive and comprehensive signal processing, including factory loudspeaker presets, which turns the amplifier into a complete audio solution. The Nyquist networked power amplifier uses the latest in Class-D amplifier technology and provide remarkable sonic quality, exceptional reliability, and reduced heat output for increased operating efficiency.

For Paging and Audio Distribution    4/8 Ohms and 25/70V Outputs    4 Balanced Phoenix + 4 RCA Inputs    Route Line Inputs Thru Nyquist Network    GUI based DSP Control    16-Band Graphic EQ, 7-Band Parametric EQ    Fully Adjustable HPF, LPF, BPF    Compression, Limiter, Noise Gate    2 x 600W Bridge Mode    Includes Phoenix Connectors & Power Cord

• Four dedicated balanced line inputs (Phoenix plug and RCA)
• Line inputs can be routed-out over the Nyquist network
• Network-based audio input (paging, audio distribution)
• 4-ohm, 8-ohm, 25V, and 70V outputs
• GUI based DSP control
• Switch selectable 4-Channel, 3-Channel or 2-Channel bridged

• 16-band Graphic Equalizer
• Signal Present and Clip Monitor LEDs
• Adjustable High Pass, Low Pass, and Bandpass Filters
• Noise Gate
• Compressor/Limiter
• 7-band Parametric Equalizer

Related Questions and Answers

Q: 1. What is the antenna for?

A: The antenna on the Pyle Pro PTA1000 Professional Stereo Power Amplifier is for the Bluetooth receiver.

Q: 2. do you have to have a special module for tel intercom?

A: thank you for your question. To connect tel intercom you would need to purchase the BH# BOTEL1S Bogen Communications TEL1S Telephone Input Module.

Q: 3. Hi, Does the amp include the power supply?

A: The Atlas Sound Time Saving Devices TSD-PA252G does not ship with power supply. It must be purchased separately.

Q: 4. Can you connect this to home audio receiver?

A: Not from the speaker outputs on the home audio receiver. Only if it has pre-outs available for that. A lot of models only have pre-outs for use with powered subwoofers.

Q: 5. how do i hook it up?

A: It depends on application. What purpose does the amp serve (i.e. background music with paging etc.). Let me know how you plan to use it and I can probably poit you in the right direction.Andy

Q: 6. Can this amp power 13 in ceiling round speakers in a small office? If so how do they need to be wired to the amp? Dave

A: It depends on the power consumption of the speakers. If you are using 70 volt speakers, which is more likely than not, you will wire the speakers in series. You will also need to purchase the appropriate input modules for you audio source.

Q: 7. I know Bose makes one for the sub, but would this pyle work with a Bose b1 subwoofer? The Bose amp is really expensive and I am looking for a cheaper alternative. Thanks in advance.

A: I use this amp as a talk-back and monitor amp driving 2 JBL P60 speakers and it has plenty of power. I don't know if it would drive a sub-woofer. It all depends on the size and wattage of the Bose I guess. If it's over 250W it might not do the job.

Q: 8. Can this amp be used to power MCM 55-10345 tweeter array? These are not powered and can't be heard, or would some other small amp work? Any suggestions. Thanks, EYD.

A: Yes it can.

Q: 9. where can i get a wiring diagram for this?

A: The user manual includes input and output wiring diagrams. Here is a link: http://www.bogen.com/products/pdfs/telephonepagepdfs/TPU35Bm.pdf

Q: 10. Is there an amp that is just like the C60, but without the telephone input and without paging? To be used to replace our Bogen C35 that we use just as an amp, in our church. I know, we don't have to use the telephone and paging section, but doesn't that add to the expense. Thank you much. Jerry Wilbanks, Sr.

A: The Behringer Eurocom SN2108 would be a good alternative if you are looking for a 70v amplifier without the telephone paging feature. This amplifier features 80 watts of total power.