The Avenger C880 Universal Head - Versatile Gripis part of the C825 Double Telescopic Hanger. It accepts a Junior (1-1/8") stud or spigot. Its retractable 5/8" stud can also support a fixture or grip accessory with a matching receiver.

1-1/8" Junior Receiver    Retractable 5/8" Stud    Load Capacity: 88.2 lb

Related Questions and Answers

Q: 1. Does the Avenger D400 4.5 support arms(booms) larger than 5/8 (16mm) in diameter? I have the Avenger D420 & D410 and they can use up to 25mm(1 ) sized poles. I was wondering if this grip head also had the larger holes(in addition to 5/8 and 3/8 )?

A: The actual opening when fully closed, of the large hole, is inch. It should work correctly for a 1 size pole.

Q: 2. Is this similar to the Manfrotto one, are they the same?

A: Thank you everyone.

Q: 3. What is the weight of this part

A: The following unit weighs in at 2.5 lbs.

Q: 4. The image does not show the rubber cover on the grip handle. Does the Avenger D200 include the rubber cover on the T-handle?

A: The blue rubber handle cover is included with the D200B, despite it not being pictured.

Q: 5. What size tubes can this clamp hold?

A: The slotted disc accepts round tubes of 10/13/16mm diameters.

Q: 6. Can this be used to mount a camera on c-stand extension for overhead shots? This would be attached to a ball head. But with what , I am unsure.

A: Impact has a prebuilt kit for C stand over head shots. https://bhpho.to/2LZQYmm

Q: 7. Can I use the Avenger RH353 Reflector Holder with a Manfrotto 5001B?

A: I use my RH353 with a Manfrotto 5001BAC...had some difficulty attaching the clamp to the top section of the light stand, as the diameter of the light stand pole seemed a bit too large for the RH353's clamp. Ultimately got it to work, though. Used indoors only with a 40 collapsible reflector attached with the holder at approx. 90 degrees to the light stand, and the whole rig was very stable. BobH

Q: 8. Can the junior pin be removed?

A: Yes it is.

Q: 9. Can this mini grip head be used separately for other purposes than the reflector holder or is it made specifically for this reflector holder? Can the boom be detached from the grip head?

A: The boom clamp (grip head) for this arm can be separated from the arm. While it can fit tube diameters from 0.5-0.75”, it is best used with this particular arm.

Q: 10. I made the mistake of purchasing a cheaper alternative and the grip head wiggles on the clamp. Is this an issue with these too?

A: When the grip head is tighten down on the Avenger D230 Super Clamp Grip Head (Black) it does not move. It is very well made.