The Neewer Portable Background Reflector Holder Clip 2-Packfrom Neewer Portable Background Reflector Holder Clip 2-Packare necessary when shooting with a reflector. They are designed of aluminum alloy with a satin silver finish. The surfaces of the clips are smooth so there is no need to worry about scratches. Besides being sturdy and durable, they are quite simple to use, just attach the clip to the light stand via reflector. They come in a package of two.

Necessary When Shooting with a Reflector    Aluminum Alloy / Satin Silver Finish    Sturdy and Durable    Surface of Clips Are Smooth

The portable background and reflector clips are necessary when shooting with a reflector.

The surfaces of the clips are smooth, no need to worry about scratches.

It is easy to assemble and disassemble.

It is quite simple to use them. Just attach the clip to the light stand via reflector when positioning is needed.

They are consisted of aluminum alloy with a satin silver finish, sturdy and durable.

Related Questions and Answers

Q: 1. can this be used to hold a circular reflector horizontally, to create an overhead white surface for bounce flash? (like a white ceiling)

A: Yes it can hold a reflector horizontally. If you look at the magnified image of it you'll see that the two clips that hold the reflector are adjusted with a thumb turn screw. This allows the clips to not only slide along the arm but also rotate 360 degrees around the arm as well. So they can be turned horizontally. Or in any orientation to the arm.Just be aware you may need to add a bit of weight to help counter balance the arm for safety. As well as a sand bag for the light stand. Hope this helps.

Q: 2. Does this fit Elinchrom RQ Hybrid Flash Heads? Any adapters needed?

A: You need a special adopter for it. Ask for their brochure it tells you what adopter to use

Q: 3. Are these lights dimmable?

A: The Neewer 4-Light Kit with Background Support System BH #NE66600015 are not dimmable.

Q: 4. will this hold the 42x70 oval reflector in a vertical position?

A: I don't think so, the specs say up to 60. I think 70 would be too big for one reflector holder like this.

Q: 5. Does this allow you to adjust the angle of the reflector? or is there a better solution?

A: No it does not allow to adjust the angle , better solution Impact Telescopic Collapsible Reflector Holder BH #IMLDHT

Q: 6. Are the shafts covered in grease to allow the air cushioning to work or are they clean?

A: There's no grease. They're clean. I do photo and video, I find them a bit of a pain (sticky) to open and collapse compared to my higher end stands. For the price, they'll do.

Q: 7. Can this be used to hold a collapsible background?

A: Yes, the Impact Collapsible Reflector Holder can also be used to hold a collapsible background.

Q: 8. How many inches do the rollers extend past the rolls of paper?

A: We do not have this in stock at the time of receiving this question to measure exactly but it should stick out approximately 3-4 inches past the end of the roll on either side. .

Q: 9. What is the max weight load for the light stands?

A: The stands in the Neewer 4-Light Kit with Background Support System BH #NE66600015 are kit not specified for load limits.

Q: 10. With two of these light stands and a crossbar, can it support background paper?

A: I don't try, but I believe it can hold the bar plus the aper