The PDMOVIE REMOTE AIR PRO 3 SYNC for RED DSMC2from PDMOVIE REMOTE AIR PRO 3 SYNC for RED DSMC2allows you to power your REMOTE AIR PRO 3 follow focus motor and communicate with your RED DSMC2 digital cinema camera with just one cable. Remote recording signals are delivered between the motor and the camera by a 6-pin LEMO-type and a 4-pin LEMO-type connector, respectively. The cable terminates in a D-tap plug, which provides power to the REMOTE AIR PRO 3.

For PDMOVIE REMOTE AIR PRO 3    Compatible with RED DSMC2 Camera    1 x 6-Pin LEMO-Type Connector (Motor)    1 x 4-Pin LEMO-Type Connector (SYNC)    1 x D-Tap Connector (Power)

Related Questions and Answers

Q: 1. Hello ! Does this fit on KipperTie Chinstrap mount support ?

A: The KipperTie Chinstrap Support comes with side support ribs with two M4 threads that seem to line up with the Wing Grip's M4 mounting points. It would be best to reach out to KipperTie since B&H does not carry their products.

Q: 2. Will this work with a mavic air 2

A: This will not work for the newly designed Mavic Air 2 controller.

Q: 3. Just to be sure. If the Wing Grip mounts on both sides of Komodo, will it work fine with Komodo Outrigger Handle?

A: Yes, The RED DIGITAL CINEMA KOMODO Wing Grip can mount to either side of the Komodo. If you use the Outrigger handle you would not be able to install a wing grip where the outrigger handle is located. So you would only be able to use the KOMODO Wing Grip on one side when paired with the Outrigger handle.

Q: 4. Will this work on Gemini?

A: Yes it will.

Q: 5. Can you run HDMI and SDI at the same time? RED GEMINI

A: You will only be able to use one output at a time.

Q: 6. Will this work on top of the camera to use easy rig

A: The RED DIGITAL CINEMA KOMODO Wing Grip is for side use only.

Q: 7. Is it compatible with wooden camera top and bottom plates?

A: This device connects directly to the RED DSMC2 Camera's Right Side. It should still work with a top and bottom plate on the camera, it would just depend on the exact model of plates and how they sit on the camera.

Q: 8. is it compatible with red epic dragon 6k?

A: It is compatible with the WEAPON 8K S35, WEAPON 6K, as well as the EPIC/SCARLET-W, and the RAVEN.

Q: 9. Can I install this over existing Komodo cage ribs or do I need to remove the ribs to install these?

A: The RED DIGITAL CINEMA KOMODO Wing Grip is designed to be mounted directly to the right side of the Komodo.

Q: 10. I'm guessing this does not work for DSMC3 cameras such as the new Red Raptor. Is there any way to make it work/what is a good alternative?

A: Unfortunately the RED DIGITAL CINEMA DSMC2 Side Handle is not compatible with RED DSMC3 cameras like the RED V-Raptor. Since the V-Raptor does not have a dedicated R/S trigger handle, you can take advantage of the EXT port and rig a 3rd party accessory to control R/S.