The MXNet 10G SDVoE Transceiver with Audio Downmixingfrom MXNet 10G SDVoE Transceiver with Audio Downmixingsimultaneously leverages the full technological architecture of its stablemate, while augmenting platform versatility through the addition of high bitrate downmixing capabilities to an already powerful silicon resume. When the transceiver is selected for transmitter mode, preparing to encode and digitally packetize a multi-channel source for multicasting throughout an MXNet 10G ecosystem, a proprietary eight-channel bit stream audio downmixing decoder intercepts Dolby Atmos, IMAX Enhanced, or other high bitrate lossless audio codecs. This decoder extracts, converts, and configures a balanced analog stereo signal, making it available for output to third-party distribution systems via a balanced Phoenix connector.

8 x CH Audio Downmixing to 2 x CH    HDMI 2.0    Dual-10GbE Ports, Copper, or Fiber    Multi-View Support

Related Questions and Answers

Q: 1. What drives are compatible or supported on the Multidock 10G?

A: Any 2.5 inch solid state disk is compatible with the Blackmagic Design Multidock 10G. https://www.bhphotovideo.com/c/products/internal-hard-drives/ci/6525?filters=fct_form-factor_2238%3A2.5in

Q: 2. Does it come with a power cable?

A: No. You will need to supply a standard IEC power cable.

Q: 3. compatible with Sony A7S??

A: The Pocketwizard PlusX is compatible with the a7S, yes.

Q: 4. Is it possible to chain two of these together, then both used on two computers?

A: You can use as many Blackmagic Design MultiDock 10G's as needed for any project, they mount like a drive bay with 4 drives, so there is no "daisy chain," necessary.

Q: 5. Is this a hardware raid device?

A: No, the MultiDock 10G is not a RAID device.

Q: 6. olympus one

A: The PocketWizard PlusX 2 Pack BH #POPWPX2P is manual and fires from a center pin. Any camera with a centerpin hot shoe can use it.

Q: 7. will these work with the Nikon Z8?

A: Yes, the PocketWizard PlusX is compatible with the Nikon Z8.

Q: 8. Will this works with older profoto pack with integrated pocketwizard?

A: Yes this unit is backwards compatible with built in Pocket Wizard receivers found in many Profoto power packs or monolights.

Q: 9. Are these compatible with Profoto and if so, do I need to order any other sync cords?

A: Yes, the Pocketwizard PlusX is compatible with most of the Profoto line.You will need a PlusX for each Profoto and one for your camera. It comes with a sync cord with adapters so you can use it without the need of other sync cords.Note the PlusX is a manual sync so it will sync the strobe, but it is not TTL or have the ability to change power from the camera.

Q: 10. Can two PlusX (transmitter) trigger 1 PlusX (receiver) simultaneously without interfering? A situation when the 2nd shooter is also using 2nd transmitter to trigger the same strobe the first shooter is triggering ?

A: If you've got two photographers in the same studio, each with a PlusX transceiver on their camera (set to the same channel), they can both trigger the strobes. The receiver doesn't care where the signal comes from, just that it's the right frequency. The limiting factor will be the recycle rate of the lighting units (which can be a few seconds, depending on their settings) so if you both try to trigger the strobes at the same exact time, they'll only fire once.