This Foba A-300 Studio Stand Accessory Holderfrom Foba A-300 Studio Stand Accessory Holdercan be mounted on the left or the right side of the A-300 studio stand crosspiece. It attaches to a standard 5/8" spigot and is securely tightened with a knob.

A-300 Studio Stand Accessory Holder

Related Questions and Answers

Q: 1. What is the thread size of this stand?

A: The On-Stage SB9600 features a 5/8 threading.

Q: 2. What is the weight capacity when configured at 90 degrees?

A: The Glide Gear Multi-Mount Home Studio Desktop Video Stand Holder Rig has a weight capacity of 4lbs at a 90°.

Q: 3. From what country were they made?

A: The Roland RH-300 headphones are manufactured in Taiwan.

Q: 4. How wide Is the base measuring from floor at the center column to the edge of the leg?

A: 21".

Q: 5. The bottom collar on this lightstand has broken. I purchased a Porta Stand PS-3 collar to replace it but it's 1/8 too small in diameter for both the lower and upper leg sections. Are there any replacement parts available?

A: To obtain the replacement part you need, it would be best to contact Impact directly for assistance. The following link would be to their contact information: http://bit.ly/1g7INv4

Q: 6. Is there any type of counter weight made to help balance this?

A: Just buy some simple sand bags to hold the legs of the stand down. Simple sand bags are what the industry uses for this purpose.

Q: 7. There sint any instructions, How do I make this stand go Horizontal ?

A: There is a small rounded knob just next to the ratchet handle which you would need to loosen first. Next, you would pull the arm which has the reflector clips on it straight up until you can see the end of the arm. Lastly, you need to tilt the arm to your left or right (depending on which orientation you are standing in) and lock down the same knob mentioned earlier.

Q: 8. Can you take out the clip from the end and put it on the other end of the boom arm? I am trying to put a reflector so that the weight is equally balanced on both sides - specially when I do not need to extend it.

A: The Integral Reflector Clip on the Impact Multiboom Light Stand is able to slide up and down the length of the boom arm, but is not designed to be removed and attached to the opposite end of the boom arm. However, do note that there is a hole on the tail end of the boom onto which you may connect a counterbalance weight to offset any weight difference.

Q: 9. I have a 13inch MacBook... Will this stand accommodate my laptop?

A: Note: Platform Size 12.25 × 17" (31 × 43 cm) 13.3" MacBook: Dimensions 11.97 x 8.36 x 0.63" / 30.4 x 21.23 x 1.55 cm Looks like a fit!

Q: 10. What is the widest compatible table to fit the mounting clamp?

A: The Glide Gear Multi-Mount Home Studio Desktop Video Stand Holder Rig Video has a clamp for mounting to tables up to 3" thick.