The Lectrosonics DSR4EXTUSB is a bottom plate adapter for the DSR4 four-channel digital slot-in receiver that adds USB-C functionality, allowing you to use Lectrosonics' Wireless Designer software for monitoring, channel setup, scanning, and frequency coordination. The plate also provides two external audio outputs via TA5M connectors and a 4-pin Hirose DC jack for power. Firmware updates must be done with the micro-USB connector on the top panel of the unit. A power cable is not included.

Bottom Adapter Plate    Adds USB-C Port to DSR4 Receiver    Two TA5M Audio Connectors    Hirose 4-Pin Power Connector    Use Receiver with Wireless Designer    Remote Control over Receiver Functions

Related Questions and Answers

Q: 1. Is this plate compatible to manfrotto 501 head

A: No, it does not.

Q: 2. Does this fit on the flycam redking stabilizer? I lost my mounting plate and need a replacement.

A: The plate is a Manfrotto 501PLong. Axler QRP-501L Quick Release Plate (Long) BH #AXQRP501L • MFR #QRP-501L OR Manfrotto 501PLONG Quick Release Video Camera Plate BH #MA501PLONG • MFR #501PLONG

Q: 3. When the QR plate is installed on this adapter, is the camera screw aligned over the center of the adapter base? I need to know if I will be able to use this with my matte box on my 15LWS standard shoulder rig.

A: Hi Edward. yes!. I use aligned on center the base plate end the camera.

Q: 4. Will this work with a Sachtler Ace sideload plate? If not what will (other than Sachtler)

A: Yes, the Libec QR Adapter Plate is compatible with the Sachtler side load plates.

Q: 5. Are there other pictures of this adapter available anywhere? Or even a Spec/drawing sheet so I can tell if it will line up with my rig?

A: Unfortunately none that we have to offer you. You would need to contact the manufacturer directly and they may have the type of information you're looking for. See below for Shape's contact info:Shape:Tel: 888-968-9810or 450-812-4712Email: a href= http://contact@shapewlb.com target= _blank contact@shapewlb.com/aWebsite: a href= http://www.shapewlb.com/ target= _blank http://www.shapewlb.com//a

Q: 6. I ordered this but need the bezel that was not included to mount it in my camera slot. How can I get one?

A: Which camera is it?

Q: 7. What adapter do I need to connect to a Zoom H4n?

A: Hi Gabriel,I think you need to be much more specific. So you want to connect something to an H4N - but what exactly do you want to connect to it?Howard

Q: 8. when it says "compatible with select Manfrotto heads" does that mean that we could use the plate from a manfrotto head (ie 608) and lock it to this plate?

A: the plate is only compatible with the Manfrotto Heads that take the 501 Pl quick release plate, the 608 is not one of those heads

Q: 9. Can anyone tell me the length of the plate? Thanks

A: Hi Chris. In fact the former answer is right both pieces are 3.5 inches length. Thanks for your interest in SHAPE products.

Q: 10. Is this basically the same as a Manfrotto 577 Rapid Connect Adaptor BH #MA577? Also just confirming doesn't come with a slide plate and you'd need to purchase a Manfrotto 501 PL BH #MA501PL.

A: Yes, this is a very similar quick release plate to the Manfrotto 577. Both this product and the 577 include a sliding plate.