The Pliant FleXLR-45 4-Pin to 5-Pin Female Adapter 6-Packsix-pack from Pliant FleXLR-45 4-Pin to 5-Pin Female Adapter 6-Packincludes six compact 4-pin XLR female to 5-pin XLR female adapters for use with 4-pin XLR male headsets. These adapters are compatible with all CrewCom radio packs and CUs.

For Use with 5-Pin XLR Male Headsets    Compatible with CrewCom Radio Packs/CUs

Related Questions and Answers

Q: 1. Will this work with the new Hero 10 Black?

A: The JOBY Pin Joint Mount will work with the GoPro HERO10 Black.

Q: 2. Is this large enough to clamp securely to a 46mm diameter Varipole?

A: Yes, the Impact Super Clamp with T-Handle can fit an Impact Varipole.

Q: 3. If the stud was oriented horizontally, parallel to a table, could the 1/4-20 screw end hold 5-10 lbs. without snapping off? If not, is there a stud like this made out of steel, like a QR plate's screw?

A: The 1/4" thread would not be stable for an item that weighs 5-10 lbs. If you prefer to use a quick release plate, the Manfrotto 323 RC2 System Quick Release Adapter with 200PL-14 Plate, BH # MA323 screwed into the Manfrotto 037 Reversible Short Stud, with 3/8" & 1/4"-20 Threads (Brass), BH # MA037 would be better. The Short Stud should have its 3/8" thread facing towards the bottom of the quick release.

Q: 4. Why this one costs more than Avenger E250 ? Different metal?

A: The Avenger E250 Long Double 5/8" Baby Pin is designed for use inside a super clamp or any other locking 5/8" receptor. Meanwhile, the Avenger E650 6.0" Pin with Collar is designed for use with a grip head. The collar at the end of the pin acts as an anchor to prevent the pin from sliding completely through a grip clamp.

Q: 5. Can i put it directly to camera..? No need a plate?

A: Yes, it can go straight on the camera without the plate.

Q: 6. Will this work with an Insta360 one R?

A: Yes, You will need to use the mounting frame that comes with this action camera.

Q: 7. Why you bought this pin and not the Avenger E250?

A: The Avenger E250 Long Double 5/8" Baby Pin is 6.0" long designed and made to fit into super clamp or any other locking 5/8" receptor.

Q: 8. Can it be used for a Samsung camera?

A: It can be used with any device that has a 1/4 inch screw mount, but this piece of equipment is not intended to be used with a camera, it is a gripping support not a tripod head.

Q: 9. Does it mount onto Impact Light Stand, Black (6') B&H # IMLS6B MFR # LS-6B?

A: This clamp can attach to an Impact 6' Light stand either using the 5/8 female slot with the included stud removed on the clamp or it can bit the tubing of the stand in a horizontal position.

Q: 10. WHAT ARE THE OUTSIDE DIMENSIONS ?

A: This Impact Super Clamp measures 1 5/8" wide by 4 7/8" long.