Customize your installation with the Aruba 8400X 6-Port 100G QSFP28 Advanced Switch Module. Featuring six SFP28 slots, this networks switch supports up to 100 Gb/s fiber connections. This module is designed to install into a CX 8400 chassis to fit your needs as your business grows. It also supports 40 Gb/s connections with compatible devices.

Works with CX 8400 Chassis    6 x 100G QSFP28 Ports    Modular Design

Related Questions and Answers

Q: 1. How to connect to Fuji HS-20 EXR?

A: You will need to buy a cable for your camera and a transmitter sold separately

Q: 2. Compatible with Fujifilm HS-20 EXR?

A: Yes

Q: 3. Does the laser module allow the focus module to autofocus on selected targets? Or does the focus still need to be programmed separately?

A: The edelkrone Laser Module would enable the edelkrone focus used on a HeadPLUS and HeadPLUS PRO to instantly maintain focus automatically.

Q: 4. Does it work with Pentax cameras?

A: it should but i don't have pentax camera

Q: 5. How wide is the IR beam? If someone could tell me how many degrees wide it is or just a good guess that would be great. Any information would be greatly appreciated.Thanks!James B.Thanks!

A: The beam width from the transmitter varies depending on the power setting and the distance to the receiver.For example, if the distance to the receiver is about 20 feet and the transmitter power is at high, the angle of width is about 30 degrees. Closer it is wider. On the low setting, it is about 10 degrees or less. Aiming it is not an issue. As for breaking the beam, it is a very narrow zone like less than 1 degree in each direction. Basically, the subject has to break line of sight between the transmitter and receiver.

Q: 6. I just bought a Captur Module Pro and a Captur Receiver, How do I DCM(Sync Channel) them?

A: no you can the transmitter is replaced with the pro module. hold the middle button on the pro module and turn on, the light will flash green rapidly, then hold receiver button down and turn on and they should match up.

Q: 7. Is it safe to run the motor while controlling a fluid head on top at the same time?

A: That is not something we would recommend. It is possible, but it may not work very well.

Q: 8. Does it work with Fuji film x t2 camera? Thanks.

A: along with the hl capcord F this will work with the XT2

Q: 9. Is the Capture Pro Module basically a transmitter?If I understand this product right, I can wirelessly use the Pro Module to trigger speed lights with the addition of a Receiver Module with any of the four sensors? Is it also possible to trigger a camera with just the Pro Module and a Receiver Module?Last question, what would the Transmitter Module be used for for from this link, https://a href= http://www.bhphotovideo.com/c/product/1140337-REG/hahnel_hl_captur_n_capture_wireless_shutter_flash_trigger.html target= _blank www.bhphotovideo.com/c/product/1140337-REG/hahnel_hl_captur_n_capture_wireless_shutter_flash_trigger.html/a , is this something I would need to use the Pro Module?

A: from the link provided, the pro module would replace the transmitter, allowing you to trigger from the methods the pro module provides.

Q: 10. I understand the IR beam transmitter can be set to a high or low setting. Does the transmitter go into a low power stand-by mode when not being activated? For example, if this was set up over-night would the battery quickly drain? Thanks!James B.

A: I would recommend not keeping the device on while it is not in use.