Ashly Ne4800Msc Dsp With Mic Pre Inputs & Aes3 Outputs

Ashly Ne4800msc Dsp With Mic Pre Inputs & Aes3 Outputs

Product Code: eq147975
Availability: In Stock

$10,347.00 $13,037.22

Qty

11 reviews Write a review

Description
Reviews (11)

Control and protect your sound system with the Ashly ne4800MSC, a network-enabled DSP processor that offers easy setup and control using standard 10/100 Ethernet protocol and Protea ne software. The ne4800MSC features four option bays for expanded functionality. This model includes the 4-channel mic pre input card, 8-channel AES3 output card, and CobraNet card.

The rear panel utilizes Euroblock connectors for easy and secure wiring. Additionally, the 12V Digital Logic I/O uses a 9-pin Euroblock connector that can be assigned to trigger a preset recall or push-to-talk mic function. A 10-pin Euroblock connector is for the 5 VDC Remote Level Control, which allows for up to eight user-defined remote DC level controls.

4 Analog Inputs / 8 Analog Outputs 10/100 Ethernet and RS-232 Interfaces 24-Bit A/D-D/A Audio Resolution Extensive DSP via Protea Software Suite Easy and Intuitive User Interface Wordclock I/O Option Bays for Expanded Functionality Windows Compatible

Parameters
Frequency Response	20 Hz to 20 kHz, ±0.1 dB, A>D ±0.25 dB, D>A ±0.25 dB, A>A
Dynamic Range	20 Hz to 20 kHz (Unweighted) >115 dB, A>D >114 dB, D>A >114 dB, A>A
THD + N	1 kHz, +20 dBu Analog (-1.0 dBFS Digital) >0.001%, A>D >0.002%, D>A >0.002%, A>A >0.00001%, D>D
Latency	48 kHz 1.42 ms, A>D 0.90 ms, D>A 2.21 ms, A>A 0.10 ms, D>D 96 kHz 0.71 ms, A>D 0.45 ms, D>A 1.11 ms, A>A 0.05 ms, D>D
Wordclock	Input/Output Type: 75 Ohms BNC Lock Range: 48 kHz ±4%, 96 kHz ±4% Input Impedance: Selectable 75 Ohms or High Impedance Input Voltage Range: 1.0 to 7.0 Vpp Output Impedance: 75 Ohms Output Level: 5.0 Vpp Nominal, Unterminated
Master Clock	Sources Audio Network Word clock AES3 Internal Crystal Clock Modes Prioritized Auto Switching Manual
Inputs	Analog Line Input Type: Active Balanced Euroblock Input Impedance: 20 Kilohms Maximum Input Level: +20 dB AES3 Digital Input Type: Transformer Balanced Female XLR Input Impedance: 110 Ohms Max Input Level: 7.0 Vpp
Outputs	Analog Output Type: Servo-Balanced Euroblock Output Impedance: 20 Ohms Maximum Output Level: +20 dBu AES3 Output Type: Transformer Balanced Male XLR Output Impedance: 110 Ohms Maximum Output Level: 5.0 Vpp
Other Connectors	10/100 Ethernet Port RS-232 Port Remote Level Control Logic I/O Data In/Out Ports On/Off Switch
Environmental	40 to 120°F / 4 to 49°C Non-Condensing
Power Requirements	90 to 240 VAC, 50/60 Hz 70 W Maximum
System Requirements	Computer Running Under Windows Vista, 7, 8, 10
Dimensions (WxHxD)	19 x 8.5 x 3.5" / 483 x 216 x 89 mm
Weight	10.3 lb / 4.7 kg

CobraNet, Dante, AES3, Mic input options
10/100 Ethernet and RS-232 computer interface standard
Extensive DSP available
Easy and intuitive user interface
24-bit A/D–D/A audio resolution
32-bit SHARC DSPs
Sample rates of 48 and 96 kHz
Hot-plug software control
Automatic DHCP network IP configuration
Butterworth, Bessel, Linkwitz-Riley, and Notched-Linkwitz-Riley filters
FIR filter capability
Advanced automatic feedback suppression
Wordclock input and output
Euroblock connectors for audio, preset recall, DC remote level control and data in/out
Remote controls for level, logic I/O and programmable functions
Third-party control friendly, input and output metering, multi-level security

Input source selection
Brick wall limiter
Compressor
Autoleveler controls
Ambient noise compensation (output only)
Ducking (high/low priority, trigger, filibuster, ducked program)
Gate
Advanced gate controls
Gain
EQ:
- 31-band
- Parametric 2, 4, 6, or 10 band
- High/Low Shelf 6/12 dB per octave
- All-Pass
- Variable Q HP/LP
- Notch/Band-Pass
Feedback Suppressor (inputs only and 48 kHz sampling rate)
Crossover: 2-, 3-, 4-way crossover, and High-Pass/Low-Pass filters
Delay:
- Input time, distance, and temperature at 48 kHz sampling rate
- Input time, distance, and temperature at 96 kHz sampling rate
Audio metering tool
Signal Generator Tool (pink noise, white noise, sine wave)
Matrix mixer
Processors

All programming is accomplished using standard 10/100 Ethernet or RS-232 protocol and Protea ne software on a PC platform. Hot-plug software control allows you to plug any function into any channel block, even when running live audio with no recompiling necessary. Automatic DHCP network IP configuration reduces network setup time. Multi-level software security with password access assures you a tamperproof audio system.

Related Questions and Answers

Q: 1. can the amount of bass be controled ?

A: Yes of course, there's a vol control for the bass and also u can adjust through the equalizer don't slide it all the way up the last sliding thing on both side...

Q: 2. Does the receiver have a jack to connect to speakers?

A: Yes, there are 2 sets on the back A & B; each has 2 (L&R) speakers output

Q: 3. I am wondering if I could connect wireless Microphone to this amplifier? If so, is there any instructions on how to do that? Thank you!

A: The Technical Pro MM2000 does not have a receiver built into it for direct compatibility with a wireless mic transmitter. This means that you would need to use an external wireless mic system, where the receiver is connected to one or both of your mic inputs on the Technical Pro MM2000, like the VocoPro Digital-32 for example (BH #VODIGITAL32U).

Q: 4. Can it be wired to a car system

A: The Technical Pro MM2000 is intended for use with installed sound systems and PAs, but not designed for use in automobile sound systems. Although you may be able to wire it to your car system, we would not recommend it for that purpose.

Q: 5. dose it have a remote control?

A: The MM3000 does not have a remote available.

Q: 6. Is this unit rack mountable?

A: Yes the Technical Pro MM3000 is rack mountable. You probably have to remove the handles and mount them through the holes left after you remove the handles.

Q: 7. can you hook a power amp to the mm2000?

A: I don't think so. It has a built-in amp.

Q: 8. does a remote control come with the unit?

A: The Technical Pro MM2000 does not include a remote control.

Q: 9. What if you surpass the 2gb FAT32 file limitation? Is there a way to recover the audio that was recorded beyond the 2gb?

A: Thank you for your question. once the file limitation is met there is no way to recover the audio past the 2GB mark.

Q: 10. Does it have a tuner/radio?

A: Yes, tt has FM Radio

Pierre	29/07/2024
I have a older technical pro 2000 watt receiver and still working good and wanted to upgrade, this new unit is better then expected, and loaded with options including Bluetooth, if you are serious about sound like I am , this is the one to get, I also use it for karaoke and you could not ask for better, including the price and the excellent friendly service, I was amazed by the fast delivery, they are very professional, you can tell they have been in business for a long time . Thank You and keep up the good work Pierre 5

Rebekah	27/07/2024
This is a GREAT product for installations where a few inputs are needed. It's hard to mess up operation. The one precaution I will state, is that the POWER INDICATOR LIGHT IS GREEN when the unit is OFF.... It is BLUE when it is ON... This is FRUSTRATING for people.. Even during installations, where I've forgotten - and troubleshot audio processing for 10-15 minutes before remembering this stupid feature. The unit being POWERED OFF is the ONLY reason that I've been called for troubleshooting.. I wish the power indicator LED was just OFF or RED, when the unit is switched off... Other than that little rant - I LOVE this product. It is my preferred simple in-rack mixer for stupid-proof installs. 5

Phuoc	13/07/2024
fast delivery great sound I love it! 5

TravisH	08/07/2024
I use this product in our committee rooms, legislative house, and senate chambers. It is very easy to add and network together for the perfect control. It would be nice to have a web connect feature for internet remote access control (hint, hint). 5

Victor	27/06/2024
My Technical Pro MM2000 Pro MIc Mixing Amp ARRIVED in A timely manner and was everything I expected, Thank You B&H 5

anyonymous	24/06/2024
i use this mixer for several years, live sound and recording. the preamps are clear, full and detailed. by far the best preamps for the dollar i have ever heart. 5

Billy Bob	13/06/2024
Took 6 days to get here to quebec Canada..tried it the same night with bluetooth and usb ( i have yorkville pulse 153 speakers) wow sounded so good ..i got drunk...now i plug in my mike and guitar gave it some fine tuning..wow sounded so good ..got drunk again...it performs like it should...might even get drunk again tonight.....i love it hope it last.. 5

Donald	12/06/2024
Our second one . Can’t beat simplicity and great sound 5

Pierre	27/05/2024
This is not my first Technical pro amp ,my old one is still running strong ,but the MM2000 just blew me away, I have some good quality speakers & this unit is making them work , the Bluetooth is awesome, if you’re looking for all around quality, this is the one to purchase, I was very impress with the professional service from B&H ,good people to deal with and surprising fast delivery, looking forward to my next purchase. 5