Seamlessly add mobile streaming to your home's speaker system with the addition of the 30W 2-Channel Bluetooth Amplifier PulseAudio In-Wallfrom PulseAudio. Conveniently fitting into a standard single-gang low-voltage wall box, the two 30W Class D amps' circuitry, speaker connections, and power are discretely hidden away. Once set up, you can use your mobile device to stream audio via a Bluetooth connection or use the panel's 3.5mm AUX input to connect a wired device. The panel is also programmable and addressable with a computer plugged into the USB-A input, so you can easily add and access multiple amps throughout your home.

Discrete In-Wall Audio Streaming    2-Channel 30W Class D Amplifiers    Fits into Single-Gang Wall Box    In-Wall Speaker & Power Connection    Programmable & Addressable via USB-A    3.5mm AUX Wired Audio Input    Bluetooth-Prioritized Auto Switching    4/8-Ohm Stable    Analog Volume Knob    Power & Bluetooth Status LEDs

• Auto source switching with Bluetooth priority
• Power and Bluetooth status LEDs
• Analog volume knob
• 4/8-ohm stable

Related Questions and Answers

Q: 1. Can I connect this to the headphones out of my Allen & Heath ZED-10FX mixer?

A: Absolutely, using this amplifier with a Zedi-10 mixer now.

Q: 2. What accessory is needed to easily mount the MDR.x with the through hole? So it doesn't wobble/rotate around anymore.

A: The hole in the Teradek MDR.X 3-Channel Lens Control Receiver with Bluetooth (B&H# TE150010) is typically used with a bolt for mounting it to a cage or other threaded female tap, as shown here: https://bit.ly/3Mglc0M

Q: 3. how long is the warranty?

A: The PCA-3 carries a manufacturers 1-Year Limited Warranty from Pyle.

Q: 4. Can I use speakers rated for 6 ohms with these speakers with power rms power of 35 watts? I will be using four speakers with two per channel in parallel.

A: You can use speakers rated at 6 ohms, two in parallel on each channel, however the amp will not offer the same specs as they are all referencing a 4 ohm load on each channel.

Q: 5. what is the power out put per channel ?

A: Pyle Pro PT6000CH Specs Amplifier Channels 6.0 Power Output per Channel 350 W at 8 Ohms 700 W at 4 Ohms

Q: 6. Is the MDR-X compatible with older Teradek RT systems? Would love to ditch my MDR-M for a three channel system.

A: ..

Q: 7. I'd like to bridge this to mono 150w output, is that advisable? What's the proper wiring?

A: Yes you can bridge, so long as you are using a compatible speaker that will not demand any further power from the PCA30.

Q: 8. Anyone using this with a turntable?

A: This integrated amplifier offers a dedicated RCA phone input for use with turntables without built-in phono preamps. Turntables with a phono preamp switch may be used also.

Q: 9. Does this have a built-in AM/FM receiver?

A: The Pyle Pro PTA1000BT has a built-in FM radio but no AM.

Q: 10. Does it have any voltage gain? I'd like something to make an existing headphone output louder.

A: Yes it does. I often run it from the headphone output on my mixer and you do get a reasonable increase in volume when turned right up on the HA43