A lighter version of the iconic Police Model, this limited edition sprint run Spyderco Police 4 Lightweight Folding Knife Black Satin Bladefeatures a grippy, black fiberglass-reinforced handle and a strong VG-10 stainless steel plain edge blade. It's about a half an inch longer than the Police Model when opened but weighs nearly two ounces less. The sturdy back lock prevents unintentionally closing the blade while working. The four-way pocket clip allows for tip-up or tip-down carry on either side, and the Spyderco Trademark Round Hole makes thumb-opening a breeze.

4.38" VG-10 Stainless Steel Blade    Plain Edge    Back Lock    Four-Position Pocket Clip    Fiberglass-Reinforced Nylon Handle    Thumb Hole for One-Hand Opening

• Flat-ground plain edge VG-10 stainless steel blade
• Back lock to prevent accidental closing while knife is in use
• Textured FRN handle
• Four-position ambidextrous steel pocket clip
• Trademark Round Hole for thumb-opening

Related Questions and Answers

Q: 1. Will it fit an iPhone 13 Max Pro?

A: Yes it will.

Q: 2. Is this Printer Carrying Case is compatible with DNP RX1 printer?

A: Yes dnp rx1, ds40, 620a

Q: 3. Will it fit a DNP 620a printer?

A: yes. i have that printer and use this case to carry it

Q: 4. Would a Canon TS3100 series properly fit?

A: Yes, the TS3100 Series will fit in this case with the top of the printer closed and no additional paper cassette installed.

Q: 5. Does the receiver plate accept the Tilta cage LWS baseplates?

A: You can attach the mounting plate from the Tilta Lightweight Shoulder Rig to the bottom of a Tilta LWS baseplate.

Q: 6. Support heavy rigs? like 20 25 lbs

A: Tilta does not offer a max payload for the Tilta Lightweight shoulder Rig. However it should support a 25lb rig. Also this STEADYGUM Shoulder Support with VCT solution supports up to 33lbs https://bhpho.to/3C4iLLG

Q: 7. is this rig good enough for sony pxw z80 camcorders?

A: Yes, the Tilta Lightweight Shoulder Rig (Black) would work fine with a Sony PXW-Z90 camcorder.

Q: 8. would this fit DNP -Rx1 printer?

A: I am not familiar with the Rx1. However I can tell you that it works well for my DNP DS40 with room for cables and other supplies. So you can compare the specs of the DS 40 and determine the fit for your model.

Q: 9. Is there a way to mount hardware like a follow focus to the left arm? It looks like there are some mounting holes on the top of the arm.

A: Yes, there is threading on both arms to attach accessories.

Q: 10. is this compatible with the sony a6700 ?

A: Yes, the Tilta Lightweight Shoulder Rig is compatible with the Sony a6700.