Made of steel, this 5' American DJ I-Beam LTS-50T/AS 5' Lighting Trussfrom American DJ I-Beam LTS-50T/AS 5' Lighting Trussis a replacement truss segment for the LTS-50T and LTS50T AS models that are part of ADJ's portable trussing system.

For LTS-50T & LTS50T AS Models    Straight Truss Segment    Part of Portable Trussing System    Steel Construction

Related Questions and Answers

Q: 1. Does the explore scientific 20" truss tube dobsonian have the go to function?

A: The Explore Scientific 20" f/3.6 Truss Tube Gen 2 Dobsonian Telescope BH #EXDOB203600 • MFR #DOB2036-00 has no GoTo function

Q: 2. What is the angle of the tray (eg, if the rear is at 9" what is the front at?

A: The Auray LTS-DT915 Laptop Stand is approximately 2" shorter in the front than the height in the back. So if the height in the back is set at 9", the height in the front will be approximately 7".The angle is not steep.

Q: 3. Can the 50 inch sheet of polarizing film be cut to use it on a number of studio lights?

A: Yes it can with be cut with scissors

Q: 4. What is the brightness?

A: The brightness of this LED COB light, the Interfit Badger Beam 60W AC/DC LED Monolight (B&H# INHBB60), is listed as being 609.4 fc / 6560 Lux at 3.3' or 1m. That's going to be similar to the brightness cast upon an area by a 300W traditional tungsten bulb. However, that will vary by the bulb.

Q: 5. Do I need to peel a protective film layer on this before using? I noticed the surface has bubbles all over.

A: Yes you will want to remove the protective layer of film.

Q: 6. What's the functional difference between the 0.3mm and 0.8mm versions? I'll be using this on a 600w Elinchrom strobe.

A: The thicker one is sort of like card stock. The thin one is like a sheet of paper. One is better when you need a slightly more rigid filter, the other is preferred when you need it to be more flexible.

Q: 7. How long will the battery last not in full power?

A: The battery is rated as 45 minutes in full power. It is not rated for run time at lower power.

Q: 8. Will this work on a Nikon D5500? Had one for my D80 & loved it, but different type jack on my new camera. The Bluetooth ML-L3 doesn't cut it.

A: Yes, this will work!

Q: 9. Can be mounted with goto system?

A: Can the tube assembly be removed from the mount?

Q: 10. When assembled, what is the height of the eyepiece from the ground?

A: It's surprisingly low for such a large-aperture scope. Pointed straight up at zenith, the eyepiece is at eye-height for me, 67 inches. At horizon, the eyepiece only about 20 inches off the ground.