Your 34mm riflescope will stay securely in place on your gun with this set of Trijicon Scope Rings Q-LOC Technology 34mm Lowfrom Trijicon. Designed for scopes with objective lenses up to 40mm, the 6061-T6 aluminum rings mount on a Pictinny rail with one hand and with no tools required. The spring-loaded dovetail exerts 12-16 inch-pounds of torque—enough to hold the ring in place and retain zero—even without tightening the knobs. (The knobs can be tightened to 30-38 inch-pounds.)

Height Above Rail: 1"    For Objective up to 40mm    6061-T6 Aluminum Construction    Spring-Loaded for Constant Retention    No-Tools, One-Handed Mounting    Mounts on Picatinny Rail    Made in U.S.A.

• Made in U.S.A. from 6061-T6 aluminum
• Mounts on Picatinny rail with one hand, no tools required
• Spring-loaded clamps with 12-16 inch-pound torque will hold rings in place even if knobs are not tightened
• For riflescope with objective lens up to 40mm

Related Questions and Answers

Q: 1. Will these pages fit in the box? https://www.bhphotovideo.com/c/product/42995-REG/Print_File_PF357BXW100_Archival_Storage_Page_for.html/specs

A: They are recommended for that binder.

Q: 2. Can this work on the new M-11 ?

A: The Match Technical 34mm E-Clypse EyeCup for the Leica M10 can also fit the Leica M11.

Q: 3. I'm needing something like this to fit an Audio-Technica AT875R to a Sony FS5. Do you think it might fit??

A: It should. I also have an AT875R and used this O-ring to obtain a snug fit for mic adaptor. It does the job quite well. Good luck!

Q: 4. will this fit on a Canon VI-T viewfinder?

A: No this is not compatible with the Canon VI-T viewfinder (only the Leica M10) and would not fit properly.

Q: 5. Is there a pocket on the outside for a label or other way to ID contents?

A: No, you can use an adhesive label.

Q: 6. Since it is designed for the M10, can I assume it will also work on the M10-R and M10-Monochrom?

A: That is correct, This eyecup can work with the M10-R and the M10-Monochrom.

Q: 7. Will this fit the Print File 6 strips of 6 frames storage sheets? (B&H # PR356625 MFR # 010-0050)

A: We use with sheets for slide storage. Your pages for negative strips appear too wide at 10 inches. Box is only 10-1/4 wide so your sheets will protrude as they move around the binder rings. Look at the larger boxes suggested on the PrintFile info sheet for your pages.

Q: 8. Does this work on the Sanken CS-3e on a Sony FX3?

A: Yes, the Sanken ROCS Rubber O-Rings cam be used with the Sanken CS-3e Short Shotgun Microphone and Sony FX3 Cinema Camera.

Q: 9. Hi, will it be able to secure Op TECH USA Rainsleeve (small)?

A: Yes, the Rainsleeve does not use the eyepiece to secure the sleeve to the camera.

Q: 10. do this item fit with page #PR3576100Q for 35mm film ?

A: Yes it does easily with the negative storage pages