[ Included] Helping me to connect all my old stuff. But most important is B&H, you are awesome

[4x Knob] Most important - Easy and quick setup.

This is being used on a Midas M32. The AVIO uses 2 channels such as 7 & 8 that will need to be linked.

It does require Dante virtual soundcard for pc or mac and you will need Dante controller (free) for mapping the channels needed.

This requires POE.

[8 to 384 kb/s] I am using a these (along with Dante Via) to convert a relatively inexpensive set of active speakers into Dante enabled speakers.

Only con so far is that the AVIO adapter is larger than I expected, but definitely not a deal breaker.

Pros include near infinite (not really, some limit) speaker runs using Ethernet cable (also must have POE); no ground loop him (digital signal); and the AVIO device can serve as a Dante clock device.

[4] I have had this 2 input Dante Unit AVIO for about 6 months now.  I have only used it in the studio and it has been a nice functional piece adding Dante to a stereo channel rack mic preamp unit reliably and without any issues.  I can say I originally tried a cheap POE injector from online and it didnt work. but works just fine with my Cisco SG300 router with POE.  I do wish they made 4 channel versions as well or even an 8 on the input end, to reduce the need for lots of router channels.  Otherwise, great sounding and so far rock solid.

[4x Knob] The AVIO works just like you would imagine. Plug into the network, assign what you want in Dante Controller, and presto.
Really terrific tool to have whether you need to add a last minute speaker or just working on a quick project and only need two outputs.
10/10 would recommend to everyone.

[ 1 TB Maximum] This unit is great for getting 2 channels of audio into your Dante network. Just be sure you have Power Over Ethernet, either from your switch or from an injector, and off you go!

[+20 dB ] This is best solution to bring my old stuff to Dante. But, most important is, B&H, you are awesome...super thanks.

[ Included] Used this for a balanced headphone amp off of the Dante network. Works great! Allows for two separate channels as stated. No issues.

[4x LED] We recently used this in our large church building to send audio from our Dante-enabled mixer in our main auditorium to the nursery. They are about 300' apart, so pulling audio cable would have been difficult and time-consuming, but since we had network throughout the building already, this device made it simple. Plus, since it's digital audio, there's no chance for extraneous noise to be added over long cable runs.
We also utilize video-over-ip, so our switches are already set up for POE and multicast with IGMP snooping, and this device works flawlessly with that configuration. Dante controller makes it easy to route audio and multicast streams, so we're able to distribute to multiple overflow locations easily and without hogging a lot of bandwidth.
We plan to use these devices often in our upcoming building expansion, and it will save lots of time and money not having to pull audio cable and buy distribution amps.

[Ethernet Port ] This thing works perfect. Hook it up to your network with POE, and it shows up in Dante Controller just like its supposed to, then works without another thought! Indicator lights by the RJ-45 are handy to be sure everything is working. Were using this with a POE injector, and there are no problems. Welcome to the future!