The Shure QX5 QT-AD10 AquaMic is a waterproof digital wireless bodypack transmitter compatible with Axient Digital series receivers. The transmitter features a LEMO 6-pin connector ready to accommodate the compatible lavalier of your choice (available separately) and is well suited to a wide variety of uses, including filmmaking, reality TV, and sports broadcasting.

Engineered to handle unpredictable on-set conditions and inclement weather, the AquaMic features an IP68-rated waterproof aluminum casing without controls or a screen, making it impervious to dust and fully water-submersible at a depth up to 100 feet. Setup is handled remotely via the QX5's Remote Control Audio System (RCAS) using the handheld MicCommander module (available separately). The transmitter provides up to 8 hours of operation on its built-in rechargeable battery and features a selectable 2/10/20mW RF output power.

Reality TV, Film, Sports Broadcasting    For Axient Digital Systems    Dustproof and Waterproof Transmitter    LEMO 6-Pin Connector    Gain Adjustment, Detachable Antennas    2/10/20mW RF Output, AES-256 Encryption    6640 Scannable Frequencies    High-Density Mode for More Channels    8 Hours on Built-In Rechargeable Battery    Requires MicCommander for Set Up

• For use with Axient Digital wireless receivers
• Small, aluminum, waterproof casing that is fully submersible up to 100', based on extensive testing by Q5X
• Fully washable and easily sanitized
• Encryption-enabled, secure transmission with 2, 10, or 20mW 
• Internal, lithium-ion rechargeable battery provides 8 hours of operating time at 10mW setting
• Six-pin LEMO connector (requires waterproof microphone with matching waterproof six-pin LEMO connector, available separately)
• Detachable belt clip
• Includes custom USB charging dongle and 1/4-wave whip antennas
• RCAS MicCommander provides essential remote handheld operation, management, and monitoring (available separately)

• The QT-AD10 Digital AquaMic is the waterproof version of the QT-AD10 family of transmitters and is fully submersible, making it ideal for any wet, dusty, or dirty application where a totally sealed transmitter is required. After use, the transmitter can be safely cleaned and sanitized before the next project.
• Used in reality TV, surfing competitions, professional kiteboarding, and America’s Cup Yachting, the Q5X AquaMic has proven itself in extreme, wet environments. The AquaMic has also been buried in the dirt for Major League Baseball broadcasts. The RCAS (Remote Control Audio System) eliminates the need for any physical control elements on the transmitter, so there is no point of entry for moisture to access the electronics.

• The QT-AD10 AquaMic utilizes RCAS (Remote Control Audio System), a revolutionary way to remotely control transmitter settings from a central computer or handheld remote control.
• The remote functions allow technicians to control on/off, monitor status, and battery level and make on-the-fly adjustments of frequency, mic offset, mic mute, RF power level, and grouping—all wirelessly.

While the AquaMic is compatible with a wide range of lavalier microphones, a mic with an IP57 rating for dust and water resistance is highly recommended, including the following models:

• Shure DuraPlex Series
• DPA 6060 or DPA 6061
• VT500WA or VT500X
• Point Source CO-08 or GO-09

Related Questions and Answers

Q: 1. Is this the wireless transmitter for use with the Nikon Z cameras, too? (they're not listed on the specs)

A: Yes For Z 7, Z 6, D850, and D500

Q: 2. Will it match the input signal on the output or will it change the frame rate/resolution?

A: Uneven framerates are supported through the SDI input on the Hollyland Mars 4K.

Q: 3. Sdi 3g

A: The Hollyland Mars 4K Wireless Video Transmitter has 3G-SDI I/O.

Q: 4. does this hold one kit or multiple kits?

A: According to Teradek: "This case is for Bolt XT 500/1000/3000 or XT Sidekick Sets, It can fit 1 TX and up to 2 RXs with or without dual Canon/Sony battery plate." https://teradek.com/products/protective-skb-case-for-2-bolt-xt-rx?variant=13699845947437

Q: 5. The Z6 doesn’t allow simultaneous HDMI and Snapbridge control. Does this allow you to record video via HDMI while controlling the camera via Camera Control Pro 2?

A: We have not found that ability for the camera with Camera Control Pro 2.

Q: 6. Is this equipment recognized by Lightroom or capture one? Basically can I replace the tethering cable with the wt-7a and still download into either of the programs?

A: I was able to set up a quick test where I had the WT-7 send the picture to a folder on a hard drive, then have Adobe Lightroom take the picture and perform an action to the photo.

Q: 7. Do these devices need a battery pack to function?

A: The Hollyland Mars 4K Wireless Video Transmission System comes with two wall power adapters included to power both the TX and RX. However, you will need to add batteries if you cannot be wired to wall power, like these: Genaray 2 x NP-F770 4400mAh Batteries & 2 x Compact Chargers Kit (B&H # GENPF770CS)

Q: 8. Will this Nikon transmitter work (or any of the others) on a Pentax 645z with a Profoto B1x?

A: You could use the manual one. https://bhpho.to/3xGtIyt

Q: 9. Could Canon WFT-E9A be an option shooting tethered to a computer using Capture1?

A: the WFT-E9A purpose is to send out files of photos taken with the camera.

Q: 10. does the transmitter cross convert between HDMI and SDI?

A: Yes, both the RX and TX units of the Hollyland Mars 4K Wireless Video Transmission System have cross-conversion, so operators could have an HDMI source coming in and an SDI source going out on the TX unit for example.