The easy35 Sprocket Holder by VALOI is designed to work with the easy35 Film Holder and allows you to scan beyond the image, including the open sprockets of the film. It is compatible with all easy35 units and is conveniently replaced by releasing a single screw and pushing out.

For the easy35 Film Holder    Allows Scanning of Film Sprockets    Single-Screw System

Related Questions and Answers

Q: 1. Will this work on the minimax?

A: The following Easyrig Umbrella with Holder is for the MiniMax. Easyrig Umbrella with Holder for Minimax BH #EAERIGMM055

Q: 2. I need to scan several rolls of 35mm microfilm. I know this product has 35mm and 120mm film holders does B&H have those and other accessories for CineStill Film Valoi 360 Film Advancer?

A: We do offer the CineStill Film VALOI 360 120 Film Holder, BH #CIV120HOLDER and the CineStill Film VALOI 360 35mm Film Holder, BH #CIV35HOLDER here: https://bhpho.to/34cJGXj

Q: 3. Do you have a replacement clip that is open both ends for lower part of arm?

A: We do not, but this clip is a common clamp for reflectors https://bhpho.to/305UwHN.

Q: 4. How do you attach this to a tripod with a standard ball head?

A: A spigot. IN order to attach to a tripod of some sort a spigot is needed. Please review the following item Impact Short Double-Female Round Spigot with 1/4"-20 and 3/8"-16 Threads BH #IMSRP101P • MFR #SRP-101P https://bhpho.to/2uk6anh

Q: 5. can this be used to hold a circular reflector horizontally, to create an overhead white surface for bounce flash? (like a white ceiling)

A: Yes it can hold a reflector horizontally. If you look at the magnified image of it you'll see that the two clips that hold the reflector are adjusted with a thumb turn screw. This allows the clips to not only slide along the arm but also rotate 360 degrees around the arm as well. So they can be turned horizontally. Or in any orientation to the arm.Just be aware you may need to add a bit of weight to help counter balance the arm for safety. As well as a sand bag for the light stand. Hope this helps.

Q: 6. What is the maximum branch diameter that this clamp can hold?

A: The maximum diameter that this clamp will attach to is 4 .

Q: 7. Hi. Can i use this attached with the octa clic 2.7? Thanks

A: The Profoto Clic Gel Holder is not compatible with Clic softboxes, the Clic Snoot, and the Clic Magnum.

Q: 8. How does this hold the reflector? I don't see any clamps in the photo.

A: The holder has two 'wings' that you can see in the photo - one at the top and the other at the bottom. Using your fingers, simply grab these two wings and pull them to the center post. This opens up the 'clamp' into which you insert the rim of the reflector -- then let go of the wings with your finger and boom - a nice tight grip on the reflector. I have the holder mounted on a tripod that I had been using for a strobe. It works very well - sturdy.

Q: 9. Does this allow you to adjust the angle of the reflector? or is there a better solution?

A: No it does not allow to adjust the angle , better solution Impact Telescopic Collapsible Reflector Holder BH #IMLDHT

Q: 10. For the compatibility section, these are compatible with SAM-6 plates too right? The section should be updated under compatibili

A: Yes, the ARRI SSB-9 Counterweight Holder is compatible with ARRI SAM-6 plates as well.