The 11" IRONMAN Cine Magic Articulating Arm Quick Release Mount 11"from IRONMAN Cine Magic Articulating Arm Quick Release Mount 11"makes integrating fill lights or secondary monitors into your camera rig setup a breeze thanks to its dual ball heads. The arm features quick release mounts for easy transitioning between accessories. The mounts feature a 1/4"-20 screw with ARRI anti-twist pin and retractable 3/8"-16 screw adapter. The arm also includes a cold shoe with 1/4"-20 thread for even more mounting flexibility. It supports loads up to 11 lb, accommodating most accessories, and it is constructed of stainless steel for a durable design.

11" Articulating Arm    Ball Head with Quick Release Mount    ARRI Anti-Twist Pins    1/4"-20 Screw with 3/8"-16 Adapter    Cold Shoe with 1/4"-20 Thread    11 lb Load Capacity    Stainless Steel Construction

Related Questions and Answers

Q: 1. Weight capacity. How heavy of a camera is this arm rated to hold?

A: Not sure what the official specs are but we support a Thermography camera and motorized pan/tilt mechanism from it. The combination weighs about 5 pounds. The closer the arm is to the wall the stronger it will be, and of course the more horizontal extension used it won't support as much. The lock knob can be cranked down pretty tight, and the arm and wall plate are very solid (typical for Manfrotto).

Q: 2. Can you remove the locking pins?

A: Yes, the SmallRig HawkLock H21 Quick Release Rosette Magic Arm locating pins can be detached and removed.

Q: 3. Just out or curiosity. Are the company name and serial number printed on the arm or is it a sticker?

A: The name is painted on.

Q: 4. Will this REALLY hold 6.6 lbs. if it is extended all the way out horizontally 20" with the weight at the end?

A: Yes the load capacity would be based on the full extension of the arm, so it is capable of holding up to 6.6 lbs.

Q: 5. Manfrotto 143 vs 244? Pros/Cons of each?

A: Nothing its the same magic are the only difference is that the 143 comes with accessories that are very much needed in order to complete a kit.

Q: 6. Can this model be attached to the Easy Link on the Manfrotto MT055XPRO3 ?

A: The Manfrotto 3/8" + 3/8" Adapter Spigot, B&H # MA125 can allow this arm to connect to the Easy-Link on select Manfrotto tripods. https://bhpho.to/2QlhTJZ

Q: 7. Hi. How long is the arm end to end, not counting the connectors on each end?

A: Not counting the connectors, you're looking at about 17.25

Q: 8. Will this support a Canon 1D MK4 with a 70-200mm lens?

A: That setup can support no more than 6.6 lbs.If you mean the canon 5d Mark IV and lens it is about 5.28 lbs combined. It is too close to the maximum in my opinion and at the least will tip over.I would not recommend that set up with that camera and lens.

Q: 9. I can adjust the locking handle with two allen wrenches, but how do I adjust the tension at the ball joints at the ends?

A: The ball joint tension can't be adjusted. I would recommend not placing anything over 6.61 lbs. Which is the rated payload.

Q: 10. how long is the arm at full extension?

A: Fully assembled clamped to table.....vertical distance from table top to top of camera mount surface.......21.5