Support your tablet on stage, in studio, or at home with the K&M Tablet Stand with Boom Arm - Blackfrom K&M. This tablet stand is height-adjustable from 6.1 to 12", includes a 10.2" pitch-adjustable boom arm, and can hold up to 2.2 lb. Place a tablet up to 16" wide and up to 13" tall on the tablet holder with or without its protective case. The stand is stabilized by its 9.9 lb low-profile base.

For up to 16" Wide, 13" Tall Tablets    2.2 lb Weight Capacity    10.2" Pitch-Adjustable Boom Arm    Holds Tablets with or without Case    6.1 to 12" Clutch Height Adjustment    9.9 lb Low-Profile Steel Base

Related Questions and Answers

Q: 1. Can this be mounted 90 deg vertically to extend the height of a C-stand etc? If so, will it be stable at full extension?

A: It will be slightly off axis, but it can be used vertically. The stability will depend on the stand it is used on.

Q: 2. how long is it exactly when collapsed?

A: It is 46" when collapsed.

Q: 3. Can this hold a 21" LED flapjack light (about 7-8lbs), say mounted as overhead/straight-down for table shooting? (via SuperClamp attached to table, then Avenger grip-head to angle this pole 45º, then LED light pointed down towards table) Also, same question, but for mounting a Sony A7iii camera/lens setup (about 1400gram or 3lbs setup) for overhead/straight-down shooting on table?(via SuperClamp attached to table, then Avenger grip-head to angle this pole 45º, then small ballhead, then camera/lens setup pointed down towards table)

A: This arm has a 2lb load capacity.

Q: 4. I’m curious if all the handles on this Boom arm are made of metal or are some plastic?

A: The Impact Boom Arm's locking knobs are plastic on the outside with metal components on the interior. The rachet handle is made of lightweight aluminum.

Q: 5. Hi there. Can I remove the entire boom pole or is it permanently attached to the baby receiver/ grip?

A: Regarding the Impact Aluminum Mid-Range Boom Arm, the boom is fixed and cannot be removed.

Q: 6. Is this c stand galvanized or stainless steel?

A: This is chrome plated stainless steel.

Q: 7. sandbag?

A: No, we suggest the following sand bag Impact Filled Saddle Sandbag (15 lb, Black) BH #IMSBFB15 • MFR #SBF-B-15 https://bhpho.to/3lreNYe

Q: 8. Will this work atop a Manfrotto 5001 stand with the 124 clamp?

A: The 5001B stand is way too small to securely support a boom arm, pivot clamp, and whatever you are going to put on the end of the arm. And the top section of tubing is too thin to accept the 124 pivot clamp.I would suggest you go with a stand like the 1052BAC or similar.

Q: 9. How is this arm compared to the GVM360 boom arm?

A: The GVM360 offers a better locking system. The the impact unit and includes stand with purchase.

Q: 10. Is it possible to remove the rotating stand mount from the boom arm?

A: The impact base boom does allow a end-user to remove the mount to be fine tune but we do not suggest doing so.