The K&M Mini TV Spigot Adapter - Blackconnects equipment with a 3/8" threaded socket to equipment with a M10 threaded stud. Get a secure hold with the integrated screw.

Adapts 5/8" Spigot Connections    M10 Threaded Socket    Integrated Screw

Related Questions and Answers

Q: 1. will this spigot fit into my PhotoFlex LS-B2320Y stand?

A: Sorry, I don't know. I use it in knuckles (aka gobo heads). They fit those perfectly, and let you use an 3/8 or 1/20-20 threaded attachments.

Q: 2. Is there a 1/4 female thread on the bottom of these?

A: The female 1/4" thread is only found on the top of the Manfrotto 5/8'' Spigot with 1/4'' Thread for Friction Arms (Set of 2).

Q: 3. Would I be able to mound a tripid head/ball head to the spigot in order to attach a camera at the end of it?

A: Yes , this has 1/4"-20 and 3/8" threaded ends standard for most ball heads

Q: 4. How long is the 5/8 pin side??

A: The 5/8 stud side is 1 3/4" long.

Q: 5. Could this be mounted to the ceiling with a Manfrotto magic arm?

A: Yes. The following item will be needed. Impact Conversion Socket 5/8" Female to 5/8" Female BH #IMSRP125P • MFR #SRP-125P https://bhpho.to/3J73Q4p

Q: 6. Will this attach a be free fluid head to a magic arm mount?

A: Yes the Manfrotto 3/8" + 3/8" Adapter Spigot can attach to the BeFree head and the Magic Arm.

Q: 7. What is the distance between the two sets of mounting holes? Would these work with the rear mounting points of the Genelec 8010 speakers by chance?

A: The distance between the holes in the horizontal position is 4 inches. As for distance between the holes on the vertical end, the top hole distance is 1 1/2" while the bottom hole distance is 2 3/4". Unfortunately, this plate hasn't been tested with the Genelec 8010 speaker to our knowledge, so your results may vary.

Q: 8. Could this be used as the base of a table where the top surface measures 36" x 16", a 20" tall double riser column (extended to 30") serves as the leg, and the entire load weighs about 15 lbs? Or would this idea be complete madness?

A: No, the following is a light stand base not a table base.

Q: 9. If I have a large light (like a 300d or a 120d) and I need it very close to the ground is there any reason I couldn't just put the light directly into this base?

A: This can be used by the 120d or 300d.

Q: 10. is the ball swivel removable? leaving just the base and ball rod on ceiling?

A: The swivel can be removed, but it may be difficult to re-install it.