Designed to perfectly fit the 8x10 View Camera, this Intrepid Camera 8x10 Lens Board Copal #3measures 140 x 140mm and accommodates the largest lenses with a 65mm-diameter Copal #3 shutter.

Designed for Intrepid 8 x 10 View Cameras    140 x 140mm Lens Board    For Copal #3 Shutters (65mm)    For Largest Lenses

Related Questions and Answers

Q: 1. What is the screw size and thread gauge of the screws that come with this?

A: We connected with Alan Gordon about the screws included with the Alan Gordon Enterprises Hi-Hat and Low-Hat Mounting Board (Pre-Drilled with Screws). Moreover, please note that only Alan Gordon Hi-Hats are compatible with the board. The screws and nuts included are: Cap screw is 3/8 16 by 1 1/4" Hex nut 3/8 16 nut Washers 3/8

Q: 2. Can I paint it?

A: Yes, it can be painted.

Q: 3. Can the usb support usb wireless mics?

A: Unfortunately this is not a supported function. If you were to plug a USB microphone directly into the USB port of the ZEDi-10FX, there would be no drivers available for either unit to function properly. Even though some USB devices can be plugged into some computers and function without any additional driver installations (typically computer's running macOS), the USB devices are still utilizing the computer's core audio drivers.

Q: 4. Will this paper work with an Epson P-900?

A: Yes, the Epson SureColor P900 17" Photo Printer can print on the FUJIFILM Semi Gloss RC Board by using the front paper feeder.

Q: 5. Is this different than the bottom board that comes in the F-2 originally?

A: This is the same board, just a replacement available for purchase.

Q: 6. This is listed as an accessory for the ikan IK-RSR6 Hi-Hat Riser but I don't see how they connect. Wouldn't there need to be a 3/8ths stud?

A: The Alan Gordon Enterprises Hi-Hat and Low-Hat Mounting Board is not compatible with the ikan IK-RSR6 Hi-Hat Riser (6").

Q: 7. What are the dimensions of this product?

A: Here is the product dimension sheet: a href= http://www.marshall-usa.com/optical/lenses/ccd_cmos/v-lh4.pdf target= _blank http://www.marshall-usa.com/optical/lenses/ccd_cmos/v-lh4.pdf/a

Q: 8. What is the outside dimensions of the 8x10 trays?

A: Unfortunately, we do not have the outside dimensions of each tray in the Paterson Plastic Developing Trays - for 8x10" Paper (Set of 3 One of Each Color). However, the shipping outside dimensions are 12.25 x 10.25 x 2.5" so it will be slightly smaller than that.

Q: 9. Can the mix in the usb out of the ZEDi10 FX replace my iOS camera mic for live streaming? I have been using an Apple camera connector cable with no luck so far.

A: Yes, you can use the usb out for streaming. ZEDi can be used like an interface in DAWs as well recording individual channels. To my knowledge, OBS only supports a stereo sum of a usb audio signal. If that’s still the case, you could use a ZED10fx if your intent is only for streaming and not recording. The usb put on the ZED10fx sums to stereo over usb

Q: 10. Are the ribs inverted or raised on the inside?

A: ribs are raised. at the top and bottom of the tray, the ribs are about a 1/4 inch and they quickly reduce to barely a nub in the middle. good for getting tongs under the paper or film but virtually flat in the middle.