Spice up your next event with the American DJ Mega Flash DMX EP, a lightweight, powerful 750W strobe with DMX control of the flash rate (1-15 flashes/second) and dimming (0-100%). Up to 16 units can be linked together and controlled by one controller. Flash rate and dimming can also be manually controlled by knobs on the rear of the unit. And there's a built-in sound-active mode if you want the flash to strobe to the beat of the music. The Mega Flash has a built-in adjustable hanging yoke. Supplied for use with 120 VAC.

Bright 750 Watt Lamp    Adjustable Flash Rate and Intensity Rate    1 to 15 Flashes/Second    Thermostat Protection    Large Coverage Area    Easy Lamp Replacement    Built-In Adjustable Hanging Yoke

• Powerful 750W DMX strobe light 
• Compact design 
• DMX-512 protocol 
• 2 DMX channels for speed and dimming 
• Speed and dimmer control knob on rear of unit 
• 0-100% dimming control 
• Sound active with built-in microphone 

Related Questions and Answers

Q: 1. Is high speed sync supported when using a trigger other than the Wescott, like the canon ST-E3-RT?

A: Yes it does HSS with the E3-RT

Q: 2. How many amps does the circuit need to be to use this (15, 20, 30 amps, etc)?

A: You can use it on a 15 amp breaker.

Q: 3. Can you use high speed sync with these?

A: No, the Photogenic PL1250C do not support High Speed Sync.

Q: 4. How do i maintain the capacitor in a power light?

A: No maintenance needed! Each time you power down the light the capacitor unloads by popping the tube. The Powerlights are maintenance free, just use them, and use them, and use them.

Q: 5. What would be the best case for this kit?

A: A suitable case would be the Tenba Transport: 4 Light Head Extra Deep Air Case Topload, B&H # TEAT4LX. https://bhpho.to/2JPgbNU

Q: 6. What do I need to use my pocket wiz to sync wireless?

A: The Speedotron 2403CX uses a 1/4 phono plug for the sync port. The best for Pocketwizards is to use this one, https://bhpho.to/3CORoFh .

Q: 7. HI. I want to 202vf head for 220vac. Where can I found it?

A: The operating voltage would be dependent on the power pack which the head is plugged into. The following link shows the Speedotron power packs which we offer that are 220V compatible and will accept the 202VF flash head. http://bhpho.to/1Ta63j7

Q: 8. Compatible with Godox transmitter?

A: No, the Neewer Q4 TTL Flash Strobe is not compatible for use with Godox-branded wireless transmitters. You would have to purchase the Neewer QPRO TTL Wireless Triggers designed for use with the above light fixtures. The available options for Canon, Nikon, and Sony cameras are listed on the link included below. https://bhpho.to/3NpAHGi

Q: 9. I have a Neewer Visions5 will this trigger work with that flash or vice versa, will the trigger from the neewer visions 5 work with the Q3 flash?

A: Unfortunately they would not work together. They are on different wireless systems.

Q: 10. De cuanto es el tiempo de vida util del flash y de la luz de modelaje?

A: Para el flash, no lo s. Nunca el dejado de funcionar uno en ocho aos. Sustituido dos luz de modelare. Mi Espaol esta muy mal.