Add pressure to your drum and synth sounds with the erica synths Stereo Compressor, a Eurorack compatible module that features the THAT chip-based compression circuit to keep your modular mix nimble and tight. The Stereo Compressor features stereo sidechain inputs and outputs that can be used to animate melodic layers on the beat and truly bring your basslines to life. The module is optimized for percussion sounds and will be a great addition to any Erica Synths Drum module rig. The Stereo Compressor ships with a ribbon power cable and a set of mounting screws.

THAT Chip-Based Stereo Compressor    DC-Coupled Sidechain    Gain, Threshold, Compression Ratio    Stereo Link for Level Detectors    Bypass Switch    8-Segment Output Level VU Meter    Stereo Sidechain Inputs & Outputs    Module Depth: 1.4" / 35mm    Includes Ribbon Cable & Mounting Screws

• THAT chip-based stereo compressor
• DC-coupled sidechain
• Gain, Threshold, and Compression amount (Ratio) settings
• Stereo Link for level detectors
• Bypass switch
• 8 segment output level VU meter
• Power consumption: 60mA at +12V, 22mA at -12V
• Module Depth: 1.4" / 35mm

• Audio input level: -5 to +5V
• Threshold: -40 to +10dB
• Makeup gain: -12 to +12dB
• Ratio: 1:1 to ∞

Related Questions and Answers

Q: 1. Does this mic have a power indicator light?

A: No, it doesn't have a power indicator. I wish that it did, but it is a minor inconvenience to me. I use mine with a Canon G20. When the mic is plugged in and turned on, I can see the levels displaying on the camera screen. When the mic is not on, there are no levels showing up from the external mic source. So, that acts as an indicator for whether or not the mic is powered on. But, to your question, other than the on/off switch, there is no indicator that the power is on and the battery is not dead.

Q: 2. according to the product highlights this amplifier Gli pro PVX9000 switchable from 110 to 220 Volt, is that true? pls confirmed so i can place my order. ...thank u

A: That's what is says. Gli pro PVX9000 features a switchable 115V 60 Hz/230 V 50 Hz power supply.

Q: 3. Is there a power light on the mic?

A: There is no light.

Q: 4. is it compatible with nikon d3100?

A: The Azden SMX-10 Stereo Microphone is not compatible with the Nikon D3100. You can instead use the Polsen ULW-16 16-Channel Camera-Mountable UHF Wireless System with PL-4 Lavalier Microphone: http://bhpho.to/1qC5BuY

Q: 5. How far from the sound source will this shotgun mike work? I want to record a lecture in a classroom and want to know if this mike will work from the back of a classroom.

A: I find this works best when close to the sound source. In a similar situation to what you are describing I have run an extension sounds cable ( 3.5 mm female to male) to connect to the camcorder and place the mic on a stand close to the speaker, right out of frame.

Q: 6. How wide is the IR beam? If someone could tell me how many degrees wide it is or just a good guess that would be great. Any information would be greatly appreciated.Thanks!James B.Thanks!

A: The beam width from the transmitter varies depending on the power setting and the distance to the receiver.For example, if the distance to the receiver is about 20 feet and the transmitter power is at high, the angle of width is about 30 degrees. Closer it is wider. On the low setting, it is about 10 degrees or less. Aiming it is not an issue. As for breaking the beam, it is a very narrow zone like less than 1 degree in each direction. Basically, the subject has to break line of sight between the transmitter and receiver.

Q: 7. HOW MANY WATCH IN 8 OHMS LOAD AND 4 OHMS LOAD?

A: The Gli pro PVX-9000 will be about 350 Watts at 8 ohms and about 500 watts at 4 ohms.

Q: 8. Is the Azden SMX-10 Mic compatible with the Canon Vixia HV40?

A: Yes it is.

Q: 9. Is the van speed variable and quiet at low speed.

A: The fan is fairly quiet...it speeds up to cool down as needed depending on output of power being used.

Q: 10. what are the difference between 2 amp. Gli pro pvx9000 and Gli pvx9000 equalizer?

A: An equalizer does not provide any amplification.