The Ambient ACN Tally CTRL RED Cable for RED Camerasis an ACN and tally output cable for RED cameras with a 4-pin CTRL port (DSMC2 + Expander with 4-pin CTRL port).

For RED Cameras with 4-Pin CTRL Port    For Lockit Device    ACN Metadata Out to Lockit Device    Tally Out to Motor Controllers

• Input connector: Signal from RED camera with 4-pin CTRL port 
• Dual output connectors: ACN Metadata Out to Lockit devices and Tally Out to motor controllers

Related Questions and Answers

Q: 1. Did work with dsmc1 red cameras?

A: No, the proper cable for a Red DSMC1, for use with the Tilta Nucleus-M, would the TIRS03RD cable: https://www.bhphotovideo.com/c/product/1490881-REG/tilta_rs_03_rd_nucleus_m_red_dsmc1_run_stop.html

Q: 2. Will this fit in my Leica M6?

A: Yes this product is compatible with M series cameras like the M6.

Q: 3. I'm so confused by this, because the RED Komodo doesn't have an R/S port. So how does this "plugs into the R/S port of the camera" if the camera doesn't have an R/S port? The Komodo has an EXT port that can breakout to various ports. So does this cable plug into that EXT port on the camera? Or what? Very confused by this.

A: You can purchase the Wooden Camera B-Box for the RED Komodo and there is a R/S port on the box. https://www.bhphotovideo.com/c/product/1572815-REG/wooden_camera_280500_b_box_red_komodo.html

Q: 4. Does this fit the Leica M6 and Leica M10?

A: Yes, it should fit both.

Q: 5. Will it fit leica m 240 ?

A: Yes, I have both a M240 and a Monochrom (typ246) and it works on both.

Q: 6. does it goes to red dragon 6k?

A: This is for DSMC1, the Red Dragon 6K is DSMC2. This cable will not work. Instead you need BH #TIRS02RD which is for DSMC2. https://bhpho.to/2KLnMAN

Q: 7. I am looking for a good solution to mount this to a camera. Is there a 1/4-20 mount (or similar) for this?

A: There is no mount made specifically for the Ambient Recording ACN-CL. Often times people use velcro patches or ties to fasten the unit to a rig. Alternatively, you can look at some of the 1/4-20 clamps we have. I recommend using a patch of velcro though.

Q: 8. Will this device accept an SDI signal as a genlock input, broadcast this over ACN, and output a wordclock referenced to it? I see lots of discussion of genlock output, but not input. I have a camera without genlock, and I want to avoid pops when combining HDMI + AES - SDI. Therefore I want to synchronize the audio ADC to the un-genlockable camera.

A: no this device will not work as a genlock for a camera without genlock, it's base/fundamental mode of synchronization is time code

Q: 9. Will it fit Leica Q? Thanks

A: No, the Leica Q has a different shutter release button and will not fit.

Q: 10. Will it work with a Z CAM?

A: No, this is only compatible with the RED DSMC2 cameras.