The Vicoustic VicStrip Spacer Kit Natural Oakis an acoustic kit that improves the innovative slat panel VicStrip by using the frame structure of a VicSpacer XXL with an air gap and an additional layer of PET to enhance its acoustic performance. It has been engineered for demanding rooms, such as home cinemas and hi-fi listening spaces.

For Hi-Fi and Home Cinema

The acoustic performance improvement with the two layers of PET and air gap makes the decorative VicStrip a sound-absorbing panel designed for select home cinema or hi-fi listening rooms.

• A black frame around the entire structure of the VicSpacer XXL gives VicStrip a new decorative look.
• An air gap of 40mm between the panels and the wall is achieved behind the wood structure, which was conceived to optimize the acoustic response of the panel.
• A layer of VicPET Wool with 8mm is assembled behind the VicStrip panels which reach 12mm, making the panels a double-layer with around 20mm of PET to enhance sound absorption.

Related Questions and Answers

Q: 1. how long is the warranty?

A: This would come with a 5 year manufacturers warranty.

Q: 2. Is this required to put an AT875R on the Sony FX6?

A: The Audio-Technica AT875R Short Shotgun Microphone comes with two rubber O-rings to help the mic fit securely in a camera's mic holder. You may need to use the O-rings with the Sony FX6 Cinema Camera. The Auray Rubber Spacer Sleeve for XLR Shotgun Microphones is just another option and works in the same manner, but it's larger and may be easier to keep in place. Both are used for the same purpose. We also sell the O-rings separately - Sanken ROCS Rubber O-Rings for CS-1 - 10-pack (B&H # SAROCS).

Q: 3. Does this unit make any noticeable noise during operation?

A: The, Ruggard EDC-FP80L Electronic Dry Cabinet with Fingerprint Lock (Black, 80L), is very quite.

Q: 4. Is anyone storing hard drives in their cabinet?

A: Very good place to store drives especially if you live in a more humid climate.

Q: 5. Is there a way to calibrate the humidity and/or temperature settings on the display? I have used a digital thermometer humidity gauge and an alcohol thermometer to check both: the humidity setting appears to be -5% off (35% instead of 40%, the recommended setting for lenses) and the temp is +3 F off. Too much of a +/- error for my taste.

A: I did not see any calibration instructions in the manual. The temperature in my house is 76 degrees on my thermostat and a digital thermometer. The display on my cabinet says 78 degrees and I have the AC vent closed to that room so I would expect a 2 degree difference. I have my cabinet set at 35% humidity. I live in Minnesota so it's not like our weather is wet like in Florida or dry as in Arizona. However, over the last week we had dewpoints in the high 70's and temps in the 94+ range so it's been tropical to say the least. I use my cabinet for humidity control and for storage as a clean room and only take out the gear I need rather than keeping everything in my bag. If you are sure your testing devices are accurate you can simply make the conversion and set the cabinet accordingly. The price is right for this cabinet.

Q: 6. Can this be used to "bake" analog tapes that the surface of the tapes become sticky and then gum-up the tapes heads and the tape won't play. It's usually done at 130 degrees for a few hours. ?

A: Unfortunately, the EDC-80L hasn't been tested for this specific use. The results may vary.

Q: 7. How close can these units be to a back wall while still being effective ?

A: The Ruggard EDC-125LC Electronic Dry Cabinet (Black, 125L) should be 6" away from the wall so the vents are not blocked.

Q: 8. Does anyone have the 50L and a Sony 200-600? It seems like it may fit diagonally, but possibly without the hood.

A: Yes the Ruggard EDC-50L Electronic Dry Cabinet (Black, 50L) will fit the Sony 200-600mm lens if the lens it positioned diagonally on the shelf.

Q: 9. Will this fit a Deity S mic 2s?

A: The Auray Rubber Spacer Sleeve for XLR Shotgun Microphones on Camcorders, will fit the Deity Microphones S-Mic 2S Moisture-Resistant Short Shotgun Microphone, the spacer is short enough not to cover the capsule area of the microphone.

Q: 10. I cannot get the humidity level to drop. I set it at 42% and it stays around 70-72% in one cabinet and 60-62% in the other. How do I get it to work?

A: I would recommend calling Ruggard and have them troubleshoot the issue to determine if the unit/units are defective; Tel: (212) 594-2353 Website http://www.ruggard.com/ Email cs@gradusgroup.com