The Arkay Stainless Steel Photo Processing Sink 30x36x6are constructed from 18 gauge type 316L stainless steel, with a 100% seamless construction.

An optional heavy gauge, charcoal grey stand & shelf as well as a choice of 5 or deluxe 10" backsplash's are available

The inside corners of these sinks have 3/4" radius coved corners leaving dirt no where to hide

The gauge of these models is thicker, more rugged, and longer lasting then other standard gauge steel sinks providing superior temperature holding ability

The Tapered look is extended to the outside of the where you'll find 1-1/2" rims an 1-1/2" radius coved outside corners

Each sink is painstakingly crafted to your exact specifications

The self-supporting sink stand also has that rounded and polished look of craftsmanship and quality.

All sinks are undercoated for sound insulation and condensation prevention

Related Questions and Answers

Q: 1. Does this work with double sided emulsions like xray film?

A: The Stearman Press SP-445 Compact 4 x 5" Film Processing System (4 Sheet) has not been tested with double-sided emulsion film.

Q: 2. Do the wheels pop off easily (for transportation purposes)?

A: The wheels on the Impact Lowboy Steel Stand with Wheels and Combo Head (4') are easily removable.

Q: 3. Can I hook a sandbag onto this?

A: Yes you can. This is the same stand as the 420B which comes with a sandbag.

Q: 4. Does the Stearman Press work for direct positive paper?

A: Yes it can be used for paper developing too. But paper developing is generally recommended to be done in the darkroom under a red light so you can watch the image appear before putting it into a stop bath. Paper developing times are very short (1 minute or so) while film often takes 7-8 minutes or more.

Q: 5. What is the recommended solution volume that does not cause problems due to overfill?

A: The recommended solution volume of the Stearman Press SP-445 Compact 4 x 5" Film Processing System is 16 oz.

Q: 6. Will it work with the Nikon Z series? Dependability of the product?

A: Yes, this is compatible with the Nikon Z series cameras. Hoodman makes good quality cards that have a lifetime warranty.

Q: 7. I just received this stand, but I can't figure out how to lock or tighten the boom arm. Where is the thread lock on the boom arm hinge?

A: When the boom arm is fully extended and the spring lock is pushed downward, the arm can be locking using the main ratchet handle to the left of the spring lock.

Q: 8. Can the middle telescope section be removed when a slightly low minimum height is needed ??

A: Unfortunately, the sections of this light stand cannot easily be removed, as it would have an impact on the sturdiness of the stand.

Q: 9. Will this tripod be a suitable replacement tripod for a Celestron CG-4? If not, which tripods are suitable even if overkill?

A: In regards to maximum weight capacity the iOptron 1.25" Stainless Steel Tripod is compatible with the iOptron 1.25" Stainless Steel Tripod. However, it is proprietary to accept the SkyHunter GoTo mount SkyGuider Pro tracking mount iPano AllView camera mount SkyTracker/SkyTracker Pro camera mount SmartEQ/SmartEQ Pro mount SmartStar/Cube mount with an M8 mounting hole SmartStar/Cube mount with a 3/8" mounting hole

Q: 10. Will the sky watcher str adventurer 2i fit /screw into this

A: iOptron did lot list it in its compatibility chart: Compatibility SkyGuider Pro tracking mount iPano AllView camera mount SkyTracker/SkyTracker Pro camera mount SmartEQ/SmartEQ Pro mount SmartStar/Cube mount with an M8 mounting hole SmartStar/Cube mount with a 3/8" mounting hole