The Arkay Stainless Steel Photo Processing Sink 24x96x6are constructed from 18 gauge type 316L stainless steel, with a 100% seamless construction.

An optional heavy gauge, charcoal grey stand & shelf as well as a choice of 5 or deluxe 10" backsplash's are available

The inside corners of these sinks have 3/4" radius coved corners leaving dirt no where to hide

The gauge of these models is thicker, more rugged, and longer lasting then other standard gauge steel sinks providing superior temperature holding ability

The Tapered look is extended to the outside of the where you'll find 1-1/2" rims an 1-1/2" radius outside corners

Each sink is painstakingly crafted to your exact specifications

The self-supporting sink stand also has that rounded and polished look of craftsmanship and quality.

All sinks are undercoated for sound insulation and condensation prevention

Related Questions and Answers

Q: 1. Is this strictly 4x5, or could it handle the 3.25x4.25 format? (And if not, any recommendations for what the best solution is for that size?)

A: This will only work with 4x5 film.

Q: 2. What is the latency of this device? In other words how much will the output video signal be behind the input signal from the camera?

A: Datavideo says - The theorem path delay of DVK-400's SDI IN to SDI OUT is less than 10 scan lines, but the actual delay can be 10 scan lines ~ 1 frame influenced by frame synchronizer and Genlock feature. This would be the same for INPUT and OUTPUT.

Q: 3. will this card work with Canon R5 8k RAW?

A: Yes, this would be compatible for your usage needs. When shooting at 8K DCI RAW video image quality, the Canon EOS R5 Mirrorless Camera bitrate captures video at 2,600 Mbps (megabits per second), which would be 325 MB/sec (megabytes per second). According to Hoodman, the Hoodman 512GB Steel CFexpress Memory Card has a sustained minimum write speed of 500 MB/sec, which is more than fast enough for the 325 MB/sec data stream from the Canon EOS R5 Mirrorless Digital Camera for 8K RAW video recording usage needs.

Q: 4. Does it have springs to prevent crushing fingers, when retracting sections?

A: No. The following unit is not air cushioned and offers no springs.

Q: 5. Is there a documented maximum weight for the subject? Anyone have any problems with the seat sliding down when someone is sitting on it?

A: I have used these stools in the school day photo environment for years. I have never had a problem with sliding from a persons weight. Believe me we have seen it all. You should not have any issues.

Q: 6. Does the Stearman Press work for direct positive paper?

A: Yes it can be used for paper developing too. But paper developing is generally recommended to be done in the darkroom under a red light so you can watch the image appear before putting it into a stop bath. Paper developing times are very short (1 minute or so) while film often takes 7-8 minutes or more.

Q: 7. Compared to the 420B, apart from lacking a sandbag, is this also a less robust stand? I notice the maximum load is lower for the 420SNB.

A: The Manfrotto 420B, B&H # MA420B and the 420NSB are the same stand, with the latter not including the empty sandbag.

Q: 8. Will this stack on top of an SKB 6U Roto Rolling Rack Case?

A: Yes the SKB 6U Roto Rolling Rack Case is compatible with SKB standard and shallow rack cases like the SKB 6U Roto Shallow Rack Case.

Q: 9. Is this large enough to hold my new lumix zs70 camera?

A: Yes it will be.

Q: 10. Can I hook a sandbag onto this?

A: Yes you can. This is the same stand as the 420B which comes with a sandbag.