This General Brand Sync Cord Extension Straight 3'is a PC male to PC female cord that adds length to a standard PC male to male cord.

PC Male to PC Female

Related Questions and Answers

Q: 1. Does this adapter allow t mount lenses to focus to infinity on Exakta cameras?

A: The General Brand T-Mount SLR Camera Adapter for Exakta & Topcon allows T-mount lenses to focus infinitely on Exakta cameras.

Q: 2. what is the diameter of the bulb?

A: The diameter of this 500 PAR64 MFL Lamp is around 8 inches.

Q: 3. Will this work with a side pinch cap?

A: Not very well. Cap pops off often.

Q: 4. WILL IT WORK ON OM-1 OLYMPUS ??

A: From the research I've done, yes.

Q: 5. I have he the Jupiter 11 135mm F4 soviet lenses M39 screw mount, what's the best adapter for Olympus OMD EM1 mark ii?Thank youBernard

A: The Novoflex Leica M39 Lens to Micro Four Thirds Camera Adapter B&H # NOMFTLEI would be the best adapter you can use.

Q: 6. Trying to connect an Old Pocket Wizard PlusII Minolta Flash meter v, will this work?

A: Yes it will.

Q: 7. How long is the curly wire?

A: The length of the coiled cord in Vello QuickDraw / Straight Bracket & TTL Cord Kit BH #VECB100NCK (B&H Kit) is 3' / 1 m when extended and 1' / 35 cm when relaxed.

Q: 8. Does it fit the lumix gh series? They are Macro Four Thirds and this one is Four thirds .

A: It could. You would have to purchase a 4/3rds to micro 4/3rds mount adapter. The Olympus Four Thirds Adapter MMF-2 is the piece you need. I don't know if there is similar adapter supplied by Panasonic. Note, I used this to attach an Olympus E-PL6 camera back to a Meade EXT-90 telescope. There was a problem with this. The telescope was configured for a 35mm film camera. I had to machine down the short extension tube n order to barely get the digital camera into the end of the telescope's focus range.

Q: 9. Can you attach the Westcott 240 and this wire to a Nikon D90 or D7000.?

A: Im not 100% (I shoot Canon) but this is a a standard pc cord. I would be shocked. But check your camera. If it has a pc connection you will be good.

Q: 10. I guess this will work on my old Olympus E-500 camera. But till this fit and work with my Celestron Ultima 80? Or do I have to buy something more for it to work?

A: That is correct. This Adapter will work with your Camera. You do not need anything extra to mount this onto an Ultima 80. To attach it just peel the Eyecup off of the Eyepiece of the Scope. Then you will see a threading. This Adapter thread's onto the Eyepiece, and your Camera Body Bayonet's onto the back of the T-Ring.