This 1-stop, 3 x 3" LEE Filters 81EF Pale Amber ND Polyester 3x3" 1-Stopfrom LEE Filters 81EF Pale Amber ND Polyester 3x3" 1-Stopis made from lightweight, optical polymeric materials. The 81 Series of filters control the bluish coloration that affects daylight film. They can also remove excessive blue from the effects of electronic flash. Good for general scenics when the photographer wishes to remove the bluish cast from open shade or just add warmth to the photograph, with an 81EF having the greatest effect. Whereas the 81 Series of filters creates a feeling of warmth, the 82 Series creates a feeling of coolness.

0.3 Oprical Density

Related Questions and Answers

Q: 1. Can i use this in front of broncolor siros lights with broncolor's reflector in front? If yes, then how can i attach it?

A: The easiest way of attaching these Lee Filters to a Broncolor reflector is with the C-47 Production Clips (Matte Black, 24-Pack), BH #C41C47, leaving airspace between the two. https://bhpho.to/3rpGmBj

Q: 2. So I recently purchased these gels to cut out and use with the filter tray on the Aputure barndoors. Upon turning my 300d mkii up to 100%, it burned right through the center. Should I just be clipping these onto this light? Or are there other filter alternatives that can go in those trays?

A: It would be best to clip the gels to the barndoor leaves in order to allow for more air space.

Q: 3. Would this pouch also work for the LEE Big Stopper which is 100 mm x 100 mm? How about non-LEE round screw-on filters such as polarizing filters? Not sure if the sleeves are too deep for filters other than the LEE 100 mm x 150 mm filters.

A: Yes, you could use the LEE Field Pouch for 100x100mm or the 105mm circular polarizing filter as well as the 100x150mm filters.

Q: 4. Will this fit all of LEE 100x filters plus the grads?

A: The LEE Filters Field Pouch for Ten 100 x 150mm Filters (Sand) is designed to hold up to ten (10) 4x4" (100 x 100mm) square filters or up to ten (10) 4x6" (100 x 150mm) rectangular filters, whether they are standard neutral density filters, graduated neutral density filters, or any other effect square/rectangular filter(s).

Q: 5. Will this Lee 105mm ring also work with the Cokin XL series of 130mm filter holders?

A: This ring only fits the Lee SW150 Mark II filter holder.

Q: 6. Can this filter be used on a regular speedlight or is it only for strobes?

A: Sure! These high-quality acetate sheets can easily be cut down to fit any size required. You can simply rubberband a piece around the head of your speedlight or cut it for use inside a fitted plastic diffuser. Easy-peasy!

Q: 7. Can I used it for hot lights or studio strobes (wrapping around the bulb)?

A: You can but not attaching right near the bulb.

Q: 8. Does this gels work good on 2K or 3K Watt lights?

A: Noooooo! Don't use these gels on any tungsten lights 1K and up. I made a mistake one time and it burned right through a 1K arri. :/

Q: 9. Is this fireproof?

A: No, the LEE Filters Quick Location Pack - 24 Sheets (10 x 12") listed above are not fireproof. According to LEE Filters, they state that their standard gels are "heat resistant" to 180° degrees Centigrade (356° Fahrenheit). The filters should be used at a slight distance from halogen, tungsten, and some high-intensity LED lamps, but may eventually melt and will require occasional replacement.

Q: 10. Will the Lee filter holder fit inside this pouch?

A: The filters themselves fit very well and seem very protected. The filter holder that comes with the individual filters will not fit in the pouch. I do really like the pouch and its versatility. I would highly recommend it.