The blue Canare Starquad XLR-TRSM Cable Blue 6ftis handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik XLR and TRS Phone connectors. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. Does it comes with some kind of box or something for the hole Kit?

A: No, everything is separate. So you need to get a case or a bag if you want to have eveything neatly stored.

Q: 2. Can you use the NTG2 as a handheld microphone (e.g. for interviews)?

A: You can though Id recommend against it as it is very sensitive and will likely pick up handling noise if hand-held. It is best used on a shockmount or other stable mounting platform. Id recommend looking for omnidirectional or lav mics for interviews! Hope this helps!

Q: 3. What is the minimum equipment required to get this working with my Panasonic GH4? Just and XLR to TRS 3.5mm converter?

A: Yes! If your using an on camera solution.

Q: 4. Does this come with the webcam/iPad mount?

A: This does not include an iPad mount.

Q: 5. Is this Mic compatible with the Canon G40?

A: Yes. You will use the XLR to Mini transformer cable that is part of the kit.

Q: 6. We need to mount this from a small hole in the middle of a desk. Does this have an option to put a bolt in from the bottom instead of the clamp?

A: This particular stand utilizes a C-clamp only. For a stand that could be screwed into a table, here's an option B&H # ROPSA1.

Q: 7. What is the range of this tester?

A: Maybe up to 150' but the manufacturer has not published this specification. Contact them at: support@soundtools.com

Q: 8. How much weight does it support?

A: This broadcast arm has a payload of 1.8 lbs.

Q: 9. I'm sorry, I should have clarified my last question - I was asking if the stud/spigot that mounts to the base clamp is 5/8" in width? I'm planning on using a different clamp with a 5/8" receiver. (BH#SACSGC) Thank you.

A: The base stud/spigot is not specified.

Q: 10. Can I leave the AA battery in or do I need to remove it when I'm done recording?

A: You can leave a AA battery inside of the RODE NTG2 Shotgun Microphone as long as you will be using the mic again within a few days. Otherwise, it is always best to remove the battery from an electronic device that will not be used for a while in order to prevent damage from problems caused by the battery leaking.