The blue Canare Starquad XLR-TRSM Cable Blue 25ftis handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik XLR and TRS Phone connectors. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. We need to mount this from a small hole in the middle of a desk. Does this have an option to put a bolt in from the bottom instead of the clamp?

A: This particular stand utilizes a C-clamp only. For a stand that could be screwed into a table, here's an option B&H # ROPSA1.

Q: 2. I want to ceiling mount this. Will the springs/joints work with gravity working in the opposite direction?

A: This boom arm is not designed to be mounted from the ceiling. The clamp that attaches to the arm to the desk will not secure the arm to hang upside down. The clamp needs to be mounted upright so the arm inserts from above the clamp.

Q: 3. Can I leave the AA battery in or do I need to remove it when I'm done recording?

A: You can leave a AA battery inside of the RODE NTG2 Shotgun Microphone as long as you will be using the mic again within a few days. Otherwise, it is always best to remove the battery from an electronic device that will not be used for a while in order to prevent damage from problems caused by the battery leaking.

Q: 4. Does this include the permanent desk mount shown in photo? (Or just clamp)

A: Yes. There are two mounts included with the BA-XE4. One is the C-clamp mount and the other is the permanent flange mount.

Q: 5. Is the arm's mounting spigot 5/8"?

A: Yes the Auray BA-XE4 Broadcast Arm with Integrated XLR Cable BH #AUBAXE4 includes a 5/8-27 Threaded Mic Stud.

Q: 6. I'm sorry, I should have clarified my last question - I was asking if the stud/spigot that mounts to the base clamp is 5/8" in width? I'm planning on using a different clamp with a 5/8" receiver. (BH#SACSGC) Thank you.

A: The base stud/spigot is not specified.

Q: 7. Does this come with the webcam/iPad mount?

A: This does not include an iPad mount.

Q: 8. How much weight does it support?

A: This broadcast arm has a payload of 1.8 lbs.

Q: 9. What is the minimum equipment required to get this working with my Panasonic GH4? Just and XLR to TRS 3.5mm converter?

A: Yes! If your using an on camera solution.

Q: 10. What battery does it take?

A: The Battery The unit uses an A23 battery which is located in the Sender. The positive end of the battery should be pointed inwards, away from the cap Twist the cap to turn the unit on or off.