The grey Canare Starquad XLR-TRSM Cable Grey 3ftis handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik XLR and TRS Phone connectors. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. How much weight does it support?

A: This broadcast arm has a payload of 1.8 lbs.

Q: 2. What battery does it take?

A: The Battery The unit uses an A23 battery which is located in the Sender. The positive end of the battery should be pointed inwards, away from the cap Twist the cap to turn the unit on or off.

Q: 3. I'm sorry, I should have clarified my last question - I was asking if the stud/spigot that mounts to the base clamp is 5/8" in width? I'm planning on using a different clamp with a 5/8" receiver. (BH#SACSGC) Thank you.

A: The base stud/spigot is not specified.

Q: 4. Does this work with Beats Studio pro. Not all cables fit in the aux port and I want to be sure this one does before I buy it

A: The V-MODA 3-Button SpeakEasy Cable with Microphone and Remote (Orange), BH # VMC3SZORN, works with Beats Studio PRO headphones.

Q: 5. Will this work well for picking up actors' lines for a live theatre event?

A: The Rode NTG2 Shotgun Microphone is highly directional, meaning it will pick up what it is pointed at in a range of 2-3 feet, but not much else. Unless the actors are stationary or there is an operator that will move this mic along with the actors as they move, I would not recommend using the NTG2 for this purpose.

Q: 6. Is the arm's mounting spigot 5/8"?

A: Yes the Auray BA-XE4 Broadcast Arm with Integrated XLR Cable BH #AUBAXE4 includes a 5/8-27 Threaded Mic Stud.

Q: 7. Where is the XLR cable?

A: XLR cables are a required but not included accessory for this microphone. We list several cabling options under the ACCESSORIES tab for this microphone.

Q: 8. We need to mount this from a small hole in the middle of a desk. Does this have an option to put a bolt in from the bottom instead of the clamp?

A: This particular stand utilizes a C-clamp only. For a stand that could be screwed into a table, here's an option B&H # ROPSA1.

Q: 9. The Overview tab says The cable is specifically designed for connecting the evolution series portable EK transmitters to the professional audio outputs on microphones and line level devices. However, I believe EK should be replaced by SK since EK refers to the receivers not the transmitters?

A: Thanks for your input. It seems this may be a web error and has been forwarded to our web department for review.

Q: 10. I want to ceiling mount this. Will the springs/joints work with gravity working in the opposite direction?

A: This boom arm is not designed to be mounted from the ceiling. The clamp that attaches to the arm to the desk will not secure the arm to hang upside down. The clamp needs to be mounted upright so the arm inserts from above the clamp.