The grey Canare Starquad XLR-TRSM Cable Grey 15ftis handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik XLR and TRS Phone connectors. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. Where is the XLR cable?

A: XLR cables are a required but not included accessory for this microphone. We list several cabling options under the ACCESSORIES tab for this microphone.

Q: 2. I'm sorry, I should have clarified my last question - I was asking if the stud/spigot that mounts to the base clamp is 5/8" in width? I'm planning on using a different clamp with a 5/8" receiver. (BH#SACSGC) Thank you.

A: The base stud/spigot is not specified.

Q: 3. Can I leave the AA battery in or do I need to remove it when I'm done recording?

A: You can leave a AA battery inside of the RODE NTG2 Shotgun Microphone as long as you will be using the mic again within a few days. Otherwise, it is always best to remove the battery from an electronic device that will not be used for a while in order to prevent damage from problems caused by the battery leaking.

Q: 4. I want to ceiling mount this. Will the springs/joints work with gravity working in the opposite direction?

A: This boom arm is not designed to be mounted from the ceiling. The clamp that attaches to the arm to the desk will not secure the arm to hang upside down. The clamp needs to be mounted upright so the arm inserts from above the clamp.

Q: 5. I assume this 3.5mm cable will work with the phillips Fidelio or SHP9500 headphones - anyone know?

A: It will work with any 3.5mm headphones and Apple products.

Q: 6. Are both plugs male ends? Are both plugs straight or is one/both a 90 degree angle?

A: Both male plugs, with one in a degree, and another one straight.

Q: 7. Does this work with Beats Studio pro. Not all cables fit in the aux port and I want to be sure this one does before I buy it

A: The V-MODA 3-Button SpeakEasy Cable with Microphone and Remote (Orange), BH # VMC3SZORN, works with Beats Studio PRO headphones.

Q: 8. Can the XLR cable be easily removed?

A: Yes, the XLR cable can be removed (and replaced, if required), though it may not be an easy task.

Q: 9. Is this a stereo mic?

A: The NTG-2 is a mono microphone.

Q: 10. We need to mount this from a small hole in the middle of a desk. Does this have an option to put a bolt in from the bottom instead of the clamp?

A: This particular stand utilizes a C-clamp only. For a stand that could be screwed into a table, here's an option B&H # ROPSA1.