Canare Starquad Xlr-Trsm Cable Purple 20Ft

Canare Starquad Xlr-trsm Cable Purple 20ft

Product Code: eq172763
Availability: In Stock

$109.50 $156.59

Qty

15 reviews Write a review

Description
Reviews (15)

The purple Canare Starquad XLR-TRSM Cable Purple 20ftis handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik XLR and TRS Phone connectors. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Parameters
Connector 1	1x XLR 3-Pin Unisex
Connector 2	1x 1/4" TRS Male Straight
Cable Length	20' / 6.1 m
Connector Brand	Neutrik
Wire Gauge	21 AWG
Shielded	Yes
Color	Purple

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. Does it comes with some kind of box or something for the hole Kit?

A: No, everything is separate. So you need to get a case or a bag if you want to have eveything neatly stored.

Q: 2. How long does a single AA battery last in the mic?

A: While there isn't a published run time for AA, as they vary too much and also depend on the chemistry of the battery, on average you can expect around 50 hours (+/-)

Q: 3. does this kit work on a zoom h5?

A: Yes. You can plug the mic into any XLR input.

Q: 4. Is this Mic compatible with the Canon G40?

A: Yes. You will use the XLR to Mini transformer cable that is part of the kit.

Q: 5. Does the included shockmount work with traditional threaded pole conectivity? or is it only made for camera mounting?

A: According to the info listed there is a 3/8 -16 thread connection at the base.

Q: 6. Does the Rode NTG2 have an on/off switch?

A: The Rode NTG-2 features no on/off switch. It is recommended that you remove the batteryfrom the unit when the microphone is not in use as it is always drawing current.

Q: 7. I'm sorry, I should have clarified my last question - I was asking if the stud/spigot that mounts to the base clamp is 5/8" in width? I'm planning on using a different clamp with a 5/8" receiver. (BH#SACSGC) Thank you.

A: The base stud/spigot is not specified.

Q: 8. Does this include the permanent desk mount shown in photo? (Or just clamp)

A: Yes. There are two mounts included with the BA-XE4. One is the C-clamp mount and the other is the permanent flange mount.

Q: 9. Is the arm's mounting spigot 5/8"?

A: Yes the Auray BA-XE4 Broadcast Arm with Integrated XLR Cable BH #AUBAXE4 includes a 5/8-27 Threaded Mic Stud.

Q: 10. What battery does it take?

A: The Battery The unit uses an A23 battery which is located in the Sender. The positive end of the battery should be pointed inwards, away from the cap Twist the cap to turn the unit on or off.

Sonicland	27/09/2024
[Neutrik] Look to be well made but at a budget price. Very happy with sound and quality. 5

Frederick	17/09/2024
[21 AWG] Recommended via B&H Chat, these appear to be a perfectly economical and quality alternative to the more expensive cables available. 5

Doug	13/09/2024
[Purple] I'm doing a series of round table discussions around the country with eight talent in each discussion session. Because i'm flying to each location, space and weight are at a premium so I'm using a Zoom F8 mixer, HOSA Little Brother 50-foot sub snake and eight dpa 4061 lavaliere microphones plus accessories and a slate. Everything has to fit in a carry in a small roller case and a small back pack so i don't have to check any bags. I'm using eight of the 10-foot Remote Audio cables to split off from the sub snake to feed the lavalieres. I carry a few-25 foot XLR cables as back up's if I need a little bit more reach. The 10-foot cables made all the difference in the world for space and weight constraints due to air travel. I've used Remote Audio cables for over a decade without a single cable failure. Remote Audio makes them tight and right. 5